Wash. Admin. Code § 296-807-18060

Current through Register Vol. 24-23, December 1, 2024

Section 296-807-18060 - Use specific flanges for Type 1 cutting-off wheels

You must mount Type 1 cutting-off wheels between flanges that are:

(1) Properly relieved with matching bearing surfaces;

(2) At least one-quarter the wheel diameter.

Note:

American National Standards Institute (ANSI) B7.1-2000, Safety Requirements for the Use, Care and Protection of Abrasive Wheels, has specific exemptions for some reinforced, bonded abrasive cutting-off wheels and steel centered, diamond cutting-off wheels. These wheels are primarily used for masonry cutting and concrete sawing.

Wash. Admin. Code § 296-807-18060

Amended by WSR 15-23-086, Filed 11/17/2015, effective 12/18/2015

Statutory Authority: RCW 49.17.010, [49.17].040,[49.17].050, and [49.17].060. 03-09-009, § 296-807-18060, filed 4/4/03, effective 8/1/03.