Current through Bulletin 2024-23, December 1, 2024
Section R616-2-8 - Inspection of Boilers and Pressure VesselsA. It shall be the responsibility of the Division to make inspections of all boilers or pressure vessels operated within its jurisdiction, when deemed necessary or appropriate.1 . Boiler inspection frequency shall be pursuant to 34A-7-103.2 . Pressure Vessel inspection frequency shall be as follows: a . Heat exchangers that operate from high pressure steam or high temperature water plants shall be inspected every twenty-four (24) months. b . Autoclaves that operate above 15 psi steam pressure shall be inspected every twenty-four (24) months.c . All other pressure vessels which fall under the jurisdiction of the Division shall be inspected every forty-eight (48) months.B. Boiler inspectors shall examine conditions in regards to the safety of the employees, public, machinery, ventilation, drainage, and into all other matters connected with the safety of persons using each boiler or pressure vessel, and when necessary give directions providing for the safety of persons in or about the same. For boilers or pressure vessels inspected by an inspector employed by the Division, the owner or user is required to freely permit entry, inspection, examination and inquiry, and to furnish a guide when necessary. For boilers or pressure vessels inspected by a deputy inspector employed by an insurance company, the deputy inspector's right of entry on the premises where the boiler or pressure vessel is located is subject to the agreement between the insurance company and the owner or operator of the boiler or pressure vessel. In the event an internal inspection of a boiler or pressure vessel is required the owner or user shall, at a minimum, prepare the boiler or pressure vessel by meeting the requirements of 29 CFR Part 1910.146 "Permit Required Confined Spaces" and 29 CFR Part 1910.147 "Control of Hazardous Energy (Lockout/Tagout)".C. If the Division finds a boiler or pressure vessel complies with the safety codes and rules, the owner or user shall be issued a Certificate of Inspection and Permit to Operate.D. If the Division finds a boiler or pressure vessel is not being operated in accordance with safety codes and rules, the owner or user shall be notified in writing of all deficiencies and shall be directed to make specific improvements or changes as are necessary to bring the boiler or pressure vessel into compliance.E. Pursuant to Sections 34A-1-104, 34A-2-301 and 34A-7-102, if the improvements or changes to the boiler or pressure vessel are not made within a reasonable time, the boiler or pressure vessel is being operated unlawfully.F. If the owner or user refuses to allow an inspection to be made, the boiler or pressure vessels is being operated unlawfully.G. If the owner or user refuses to pay the required fee, the boiler or pressure vessel is being operated unlawfully.H. If the owner or user operates a boiler or pressure vessel unlawfully, the Commission may order the boiler or pressure vessel operation to cease pursuant to Sections 34A-1-104 and 34A-7-103.I. If, in the judgment of a boiler inspector, the lives or safety of employees or public are or may be endangered should they remain in the danger area, the boiler inspector shall direct that they be immediately withdrawn from the danger area, and the boiler or pressure vessel be removed from service until repairs have been made and the boiler or pressure vessel has been brought into compliance.J. An owner/user agency may conduct self inspection of its own unfired pressure vessels with its own employees who are owner/user agents under procedures and frequencies established by the Division.Utah Admin. Code R616-2-8
Amended by Utah State Bulletin Number 2019-11, effective 5/8/2019