Section 326 IAC 8-3-3 - Open top vapor degreaser operationAuthority: IC 13-14-8; IC 13-17-3-4; IC 13-17-3-11; IC 13-17-3-12
Affected: IC 13-17-3
Sec. 3.
(a) The owner or operator of an open top vapor degreaser shall comply with the following control equipment and operating requirements: (1) Equip the vapor degreaser with a cover that can be opened and closed easily without disturbing the vapor zone.(2) Keep the cover closed at all times except when processing workloads through the degreaser.(3) Minimize solvent carryout by: (A) racking parts to allow complete drainage;(B) moving parts in and out of the degreaser at less than three and three-tenths (3.3) meters per minute (eleven (11) feet per minute);(C) degreasing the workload in the vapor zone at least thirty (30) seconds or until condensation ceases;(D) tipping out any pools of solvent on the cleaned parts before removal; and(E) allowing parts to dry within the degreaser for at least fifteen (15) seconds or until visually dry.(4) Prohibit the entrance into the degreaser of porous or absorbent materials, such as cloth, leather, wood, or rope.(5) Prohibit occupation of more than one-half (1/2) of the degreaser's open top area with the workload.(6) Prohibit the loading of the degreaser in a manner that causes the vapor level to drop more than fifty percent (50%) of the vapor depth when the workload is removed.(7) Prohibit solvent spraying above the vapor level.(8) Repair solvent leaks immediately, or shut down the degreaser if leaks cannot be repaired immediately.(9) Store waste solvent only in closed containers.(10) Prohibit the disposal or transfer of waste solvent in a manner that would allow greater than twenty percent (20%) of the waste solvent by weight to evaporate into the atmosphere.(11) Prohibit the use of workplace fans near the degreaser opening.(12) Prohibit visually detectable water in the solvent exiting the water separator.(13) Provide the degreaser with a permanent, conspicuous label that lists the operating requirements in subdivisions (2) through (12).(b) The owner or operator of an open top vapor degreaser subject to this subsection shall comply with the following additional control equipment and operating requirements: (1) Equip the degreaser with the following switches:(A) A condenser flow switch and thermostat that shuts off sump heat if condenser coolant stops circulating or becomes too warm.(B) A spray safety switch that shuts off spray pump if the vapor level drops more than ten (10) centimeters (four (4) inches).(2) Equip the degreaser with one (1) of the following control devices:(A) A freeboard ratio of seventy-five hundredths (0.75) or greater and a powered cover if the degreaser opening is greater than one (1) square meter (ten and eight-tenths (10.8) square feet).(B) A refrigerated chiller.(C) An enclosed design in which the cover opens only when the article is actually entering or exiting the degreaser.(D) A carbon adsorption system with ventilation that, with the cover open, achieves: (i) a ventilation rate of greater than or equal to fifteen (15) cubic meters per minute per square meter (fifty (50) cubic feet per minute per square foot) of air-to-vapor interface area; and(ii) an average of less than twenty-five (25) parts per million of solvent exhausted over one (1) complete adsorption cycle.(E) VOC emission control equipment that complies with the following: (i) A capture efficiency of at least ninety percent (90%) by weight for the VOC emissions.(ii) Either: (AA) a destruction efficiency of at least ninety percent (90%), by weight; or(BB) an outlet concentration of less than fifty (50) parts per million, by volume, dry basis, for the VOC emissions.(iii) Compliance with the test methods and procedures in 326 IAC 8-1-4(d) through 326 IAC 8-1-4(f).(3) Prohibit the loading of the degreaser to the point where the vapor level would drop more than ten (10) centimeters (four (4) inches) when the workload is removed.(4) Prohibit the exhaust ventilation rate from exceeding twenty (20) cubic meters per minute per square meter (sixty-five (65) cubic feet per minute per square foot) of degreaser open area unless a greater ventilation rate is necessary to meet Occupational Safety and Health Administration requirements.(5) Ensure that the label required under subsection (a)(13) includes the additional operating requirements listed in subdivisions (3) and (4).Air Pollution Control Division; 326 IAC 8-3-3; filed Mar 10, 1988, 1:20 p.m.: 11 IR 2537; readopted filed Jan 10, 2001, 3:20 p.m.: 24 IR 1477; filed Jan 30, 2013, 12:33 p.m.: 20130227-IR-326070352FRAFiled 5/11/2021, 11:22 a.m.: 20210609-IR-326180542FRA