Section 4495.5 - Establishment and ToleranceData shall be compiled showing that the method used in the multiple draft weighing operation for the specific location, vehicles, and connected combinations does not introduce or result in errors not in conformance with the requirements of this article when compared to a single draft weighing operation. All testing by the Department shall be consistent with verifying the accuracy of this method. If for any reason the verification testing fails or cannot be performed safely, testing will be terminated until the deficiencies are corrected and the written request for authorization is re-submitted to the Department.
The following procedures shall be used by weights and measures officials for authorizing multiple draft weighing procedures:
(a) The applicant shall provide accessibility to all identified equipment and they shall also provide assistance from trained facility representative(s) during the verification procedures.(b) All single draft weighings will be performed with the vehicle(s) positioned in approximately the same location on the load-receiving element of the weighing device.(c) Vehicles shall be tested as used in the normal course of business.(d) Multiple draft weighings shall be performed in accordance with the applicant's written procedures.(e) A maximum of 30 single draft and 30 multiple draft net weighments shall be performed for each requested authorization.(f) At no time shall the net weights determined using a multiple draft weighing operation differ from those using a single draft weighing operation by more than twice the scale tolerance for that net load. A weighment that exceeds the established tolerance shall be sufficient grounds for the Department to deny authorization to use the multiple draft weighing procedure. The Department shall issue a letter either authorizing use of the multiple draft weighing operation or rejecting the application within 30 days following the completion of verification procedures.
Cal. Code Regs. Tit. 4, § 4495.5
1. New section filed 9-9-99; operative 10-9-99 (Register 99, No. 37). Note: Authority cited: Sections 12027, 12107 and 12735, Business and Professions Code. Reference: Section 12728(d)(2), Business and Professions Code.
1. New section filed 9-9-99; operative 10-9-99 (Register 99, No. 37).