Utah Code § 19-1-405

Current through the 2024 Fourth Special Session
Section 19-1-405 - Air Quality Board duties - Rulemaking
(1) By following the procedures and requirements of Title 63G, Chapter 3, Utah Administrative Rulemaking Act, the Air Quality Board may make rules to:
(a) certify a motor vehicle on which conversion equipment has been installed if:
(i) before the installation of conversion equipment, the motor vehicle does not exceed the emission cut points for:
(A) a transient test driving cycle, as specified in 40 CFR 51, Appendix E to Subpart S; or
(B) an equivalent test for the make, model, and year of the motor vehicle; and
(ii) the motor vehicle's emissions of regulated pollutants, when operating with clean fuel, is less than the emissions were before the installation of conversion equipment;
(b) recognize a test or standard that demonstrates a reduction in emissions; or
(c) recognize a certification standard from another state.
(2) A reduction in emissions under Subsection (1)(a)(ii) is demonstrated by:
(a) certification of the conversion equipment by the federal Environmental Protection Agency or by a state whose certification standards are recognized by the Air Quality Board;
(b) testing the motor vehicle, before and after the installation of the conversion equipment, in accordance with 40 CFR 86, Control of Air Pollution from New and In-use Motor Vehicle Engines: Certification and Test Procedures, using all fuel the motor vehicle is capable of using; or
(c) any other test or standard recognized by the Air Quality Board in rule.

Utah Code § 19-1-405

Amended by Chapter 295, 2014 General Session ,§ 4, eff. 5/13/2014.
Amended by Chapter 382, 2008 General Session