Section 372.006 - Nonwater-Supplied Urinal Performance Standards(a) A person may not sell, offer for sale, or distribute in this state a nonwater-supplied urinal for use in this state unless the nonwater-supplied urinal: (1) meets the performance, testing, and labeling requirements prescribed by the following standards, as applicable: (A) American Society of Mechanical Engineers Standard A112.19.19-2006 "Vitreous China Nonwater Urinals"; or(B) International Association of Plumbing and Mechanical Officials Standard ANSI Z124.9-2004 "Plastic Urinal Fixtures";(2) provides a trap seal that complies with the building code of the local government in which the urinal is installed; and(3) permits the uninhibited flow of waste through the urinal to the sanitary drainage system.(b) The manufacturer or importer must submit to the commission certified test results from a laboratory accredited by the American National Standards Institute verifying that the nonwater-supplied urinal conforms to the requirements described by Subsection (a)(1).(c) A person who installs a nonwater-supplied urinal shall install water distribution and fixture supply piping sized to accommodate a water-supplied urinal to an in-wall point immediately adjacent to the nonwater-supplied urinal location so that the nonwater-supplied urinal can be replaced with a water-supplied urinal if desired by the owner or required by a code enforcement officer.(d) A person who owns a nonwater-supplied urinal shall clean and maintain the nonwater-supplied urinal in accordance with the manufacturer's instructions.Tex. Health and Safety Code § 372.006
Added by Acts 2009, 81st Leg., R.S., Ch. 1316, Sec. 3, eff. 9/1/2009.