Section 49-22-05.1 - Exclusion and avoidance areas - Criteria1. The commission shall develop criteria to be used in identifying exclusion and avoidance areas and to guide the site, corridor, and route suitability evaluation and designation process. The criteria also may include an identification of impacts and policies or practices which may be considered in the evaluation and designation process.2. The commission may not identify prime farmland, unique farmland, or irrigated land as exclusion or avoidance areas when evaluating and designating geographical areas for site, corridor, or route suitability.3. Except for electric transmission lines in existence before July 1, 1983, areas within five hundred feet [152.4 meters] of an inhabited rural residence must be designated avoidance areas. This criterion does not apply to a water pipeline. The five hundred foot [152.4 meter] avoidance area criteria for an inhabited rural residence may be waived by the owner of the inhabited rural residence in writing.4. Areas less than one and one-tenth times the height of the turbine from the property line of a nonparticipating landowner and less than three times the height of the turbine or more from an inhabited rural residence of a nonparticipating landowner, must be excluded in the consideration of a site for a wind energy conversion area, unless a variance is granted. The commission may grant a variance if an authorized representative or agent of the permittee, the nonparticipating landowner, and affected parties with associated wind rights file a written agreement expressing the support of all parties for a variance to reduce the setback requirement in this subsection. A nonparticipating landowner is a landowner that has not signed a wind option or an easement agreement with the permittee of the wind energy conversion facility as defined in chapter 17-04. A local zoning authority may require setback distances greater than those required under this subsection. For purposes of this subsection, "height of the turbine" means the distance from the base of the wind turbine to the turbine blade tip when it is in its highest position.Amended by S.L. 2019, ch. 56 (HB 1383),§ 3, eff. 7/1/2019.Amended by S.L. 2017, ch. 63 (SB 2313),§ 3, eff. 8/1/2017.Amended by S.L. 2017, ch. 328 (HB 1144),§ 8, eff. 7/1/2017. See S.L. 2017, ch. 63 (SB 2313), § 5.