Section 32:322 - Use of multiple beam road lighting equipmentA. Whenever a motor vehicle is being operated on a roadway or shoulder adjacent thereto during the times specified in R.S. 32:301, the driver shall use a distribution of light or composite beam, directed high enough and of sufficient intensity to reveal persons and vehicles at safe distance in advance of the vehicle subject to the following requirements and limitations.B. Whenever a driver of a vehicle approaches an oncoming vehicle within 500 feet, such driver shall use a distribution of light, or composite beam, so aimed that the glaring rays are not projected into the eyes of the oncoming driver. The lowermost distribution of light, or composite beam, specified in R.S. 32:321, shall be dimmed to avoid glare at all times, regardless of road contour and loading.C. Whenever the driver of a vehicle follows another vehicle within 200 feet to the rear, except when engaged in the act of overtaking or passing, such driver shall use a distribution of light permissible under this Chapter other than the uppermost distribution of light specified in R.S. 32:321(1).D. Whenever the driver of a vehicle approaches an oncoming vehicle within five hundred feet or follows another vehicle two hundred feet to the rear, such driver shall not use any fog lamps or other auxiliary driving or passing lamps, except during periods of inclement weather or fog.Acts 1962, No. 310, §1; Acts 1988, No. 598, §1.Acts 1962, No. 310, §1; Acts 1988, No. 598, §1.