Section 19-2716 - METHODS OF EXECUTION(1) The punishment of death shall be inflicted by the following methods: (a) Continuous, intravenous administration of a lethal quantity of a substance or substances approved by the director of the Idaho department of correction until death is pronounced by a coroner or a deputy coroner; or(2) Not later than five (5) days after the issuance of a death warrant, the director of the Idaho department of correction must determine, and certify by affidavit to the court that issued the death warrant, whether execution by lethal injection, as described in subsection (1)(a) of this section, is available.(3) If the director certifies that lethal injection is available, the method of execution shall be lethal injection.(4) If the director does not certify that lethal injection is available, fails to file a certification as required pursuant to subsection (2) of this section, or otherwise determines that lethal injection is unavailable, the method of execution shall be firing squad.(5) If a court holds that lethal injection is unconstitutional, on its face or as applied, or otherwise determines that firing squad is a constitutionally required method of execution, the method of execution shall be firing squad.(6) The director shall determine the procedures to be used in any execution. (7) The provisions of this section shall apply to all executions carried out on and after the effective date of this enactment, irrespective of the date sentence was imposed.[(19-2716) Cr. Prac. 1864, sec. 467, p. 269; R.S., R.C., & C.L., sec. 8020; C.S., sec. 9063; I.C.A., sec. 19-2616; am. 1978, ch. 70, sec. 1, p. 140; am. 1982, ch. 257, sec. 1, p. 668; am. 2009, ch. 81, sec. 1, p. 228.]Amended by 2023 Session Laws, ch. 141,sec. 1, eff. 7/1/2023.