037-5 Wyo. Code R. § 5-10
a. All linen plats must conform to one of the standard sizes listed. Linen plats prepared on sheets of any other size will not be accepted. If one sheet is not sufficient to show the proposed works, two or more sheets of the same size may be used. Keep all map information within the border line.
b. Loose-leaf books are in use for each size given below, and all linen plats are filed flat in order to preserve the record contained on them. Linen plats must be made on sheets of the following sizes and dimensions:
| OVERALL DIMENSIONS | MARGINS | |||
| Size | Length | Width | Binding Side | Other Sides |
| B | 15" | 10-3/4" | 1-1/2" | 1/4" |
| D | 21-1/2" | 15" | 1-1/2" | 3/8" |
| E | 30" | 21-1/2" | 1-1/2" | 1/2" |
| F | 4 0" | 35" | 3/4" | 3/4" |
See pages 56 and 57 for pictorial representation of plat sizes and margin arrangements.
- (1) The "F" size sheet is very unhandy to file and to use; consequently, it is preferred that the "B", "D", or "E" size sheets be utilized if possible. The preferred plat size for ground water plats is the "B" size. Statutory provisions also permit the use of size "A" which is 8-1/2 inches wide and 11 inches long; size "AA" which is 8-1/2 inches wide and 14 inches long; and size "C" which is 22 inches wide and 36 inches long. The State Engineer's Office, however, is not equipped with books for filing these sizes; therefore, the sizes included in the above tabulation are preferred.
037-5 Wyo. Code R. § 5-10