Statutes, codes, and regulations
Wisconsin Administrative Code
Agency - Department of Natural ResourcesEnvironmental Protection - Hazardous Waste ManagementChapter NR 679 - Used Oil Management Standards
Subchapter F - Standards for Used Oil Processors and Re-Refiners
Section NR 679.55 - Analysis plan

Wis. Admin. Code Department of Natural Resources NR 679.55

Download
PDF
Current through November 25, 2024
Section NR 679.55 - Analysis plan

Owners or operators of used oil processing and re-refining facilities shall develop and follow a written analysis plan describing the procedures that will be used to comply with the analysis requirements of s. NR 679.53 and, if applicable, s. NR 679.72. The owner or operator shall keep the plan at the facility.

(1) REBUTTABLE PRESUMPTION FOR USED OIL IN S. NR 679.53. At a minimum, the plan shall specify all of the following:
(a) Whether sample analyses or knowledge of the halogen content of the used oil will be used to make this determination.
(b) If sample analyses are used to make this determination, all of the following:
1. The sampling method used to obtain representative samples to be analyzed. A representative sample may be obtained using one of the following:
a. One of the sampling methods in ch. NR 661 Appendix I.
b. A method shown to be equivalent under ss. NR 660.20 and 660.21.
2. The frequency of sampling to be performed, and whether the analysis will be performed on-site or off-site.
3. The methods used to analyze used oil for the parameters specified in s. NR 679.53.
(c) The type of information that will be used to determine the halogen content of the used oil.
(2) ON-SPECIFICATION USED OIL FUEL IN S. NR 679.72. At a minimum, the plan shall specify all of the following if s. NR 679.72 is applicable:
(a) Whether sample analyses or other information will be used to make this determination.
(b) If sample analyses are used to make this determination, all of the following:
1. The sampling method used to obtain representative samples to be analyzed. A representative sample may be obtained using one of the following:
a. One of the sampling methods in ch. NR 661 Appendix I.
b. A method shown to be equivalent under ss. NR 660.20 and 660.21.
2. Whether used oil will be sampled and analyzed prior to or after any processing or re-refining.
3. The frequency of sampling to be performed, and whether the analysis will be performed on-site or off-site.
4. The methods used to analyze used oil for the parameters specified in s. NR 679.72.
(c) The type of information that will be used to make the on-specification used oil fuel determination.

Wis. Admin. Code Department of Natural Resources NR 679.55

CR 05-032: cr. Register July 2006 No. 607, eff. 8-1-06.