Wash. Admin. Code § 296-864-40020
Current through Register Vol. 24-23, December 1, 2024
You must follow the relevant procedures in Table 3, Procedures for Inflating Split Rim Wheels.
Table 3 Procedures for Inflating Split Rim Wheels
| During these times: | Then: |
| Split rim wheels are being inflated. | Make sure employees stay out of the trajectory. |
| When all of the following occur: A tire on a vehicle has more than 80 percent of the recommended pressure; and Remote control inflation equipment is used; and No employees are in the trajectory during inflation. | The tire may be inflated while the rim wheel is on the vehicle. |
| Assembly of the wheel and inflation of the tire. | Apply rubber lubricant to bead and rim mating surfaces, unless the tire or wheel manufacturer recommends against it. |
| Inflating tires outside of a restraining device. | Make sure you do not exceed 5 psi (pounds per square inch) to seat the bead. |
| The tire is pressurized. | Make sure you don't correct the seating of side and lock rings by hammering, striking or forcing the components. |
| Note: | 1. Employees should stay out of the trajectory as much as possible while installing the split rim wheel onto the vehicle. |
| 2. The trajectory may deviate from its expected path. |
Wash. Admin. Code § 296-864-40020
Statutory Authority: RCW 49.17.010, 49.17.040, 49.17.050, 49.17.060. 04-20-079, § 296-864-40020, filed 10/5/04, effective 2/1/05.