Section 296-807-15040 - Make sure the operator uses the tool safely(1) You must make sure the operator: (a) Inspects the tool before using it, as recommended by the tool manufacturer;(b) Uses the tool according to the manufacturer's instructions;(c) Keeps the tool unloaded until just before using it;(d) Unloads the tool at once if work is interrupted after the tool has been loaded;(e) Does not leave a tool or powder load unattended where it would be available to an unauthorized person;(f) Never points a tool (loaded or unloaded) at any part of a person's body. Note: | A magazine or clip fed tool is not considered loaded until a powder load is actually in the ram (firing chamber). |
(2) You must make sure tools are not used in an explosive or flammable atmosphere.(3) You must do this if the tool misfires: (a) Hold it firmly against the work surface for thirty seconds; then(b) Follow the instructions in the tool manufacturer's instruction manual.(4) You must hold the tool perpendicular to the work surface when fastening to any material. Exemption:
This does not apply if the tool manufacturer recommends a different technique for a specific job.
Wash. Admin. Code § 296-807-15040
Amended by WSR 15-23-086, Filed 11/17/2015, effective 12/18/2015Statutory Authority: RCW 49.17.010, [49.17].040,[49.17].050, and [49.17].060. 03-09-009, § 296-807-15040, filed 4/4/03, effective 8/1/03.