Wash. Admin. Code § 173-434-130

Current through Register Vol. 24-20, October 15, 2024
Section 173-434-130 - Emission standards

In addition to the general applicability of chapters 173-400 and 173-490 WAC to all emission sources; no incinerator facility shall cause or permit air contaminant emissions in excess of the limits listed below. Specific emission standards listed in this chapter will take precedence over the general emission standards of chapter 173-400 WAC.

(1) Particulate.
(a) For incinerator facilities that are capable of burning two hundred fifty or more tons of solid waste per day, emissions from each stack shall not exceed 0.046 grams of particulate per dry cubic meter at standards conditions (0.020 grains/dscf) corrected to seven percent oxygen for an hourly average.
(b) For incinerator facilities that have a maximum capability of burning less than two hundred fifty tons of solid waste per day, emissions from each stack shall not exceed 0.069 grams of particulate per dry cubic meter at standards conditions (0.030 grains/dscf) corrected to seven percent oxygen for an hourly average.
(2) Hydrogen chloride. The hydrogen chloride emissions from each stack shall not exceed fifty ppm on a volumetric dry basis corrected to seven percent oxygen for an hourly average, except if the owner or operator demonstrates that uncontrolled emissions of hydrogen chloride are reduced by at least eighty percent and a procedure acceptable to ecology or the authority for monitoring is developed.
(3) Sulfur dioxide. The sulfur dioxide emissions from each stack shall not exceed fifty ppm on a volumetric dry basis corrected to seven percent oxygen for an hourly average, except if the owner or operator demonstrates that the uncontrolled emissions of sulfur dioxide are reduced by at least eighty percent and a procedure acceptable to ecology or the authority for monitoring is developed.
(4) Opacity.
(a) The opacity as measured visually from any incinerator stack shall not exceed an average of five percent opacity for more than six consecutive minutes in any sixty minute period.
(b) The opacity as measured by a transmissometer shall not exceed an average of ten percent opacity for more than six consecutive minutes in any sixty minute period.
(c) The opacity as measured visually shall not exceed an average of zero percent from any emissions unit except incinerator stacks for more than six consecutive minutes in any sixty minute period.
(5) Fugitive emissions. Each operator or owner shall take reasonable precautions to prevent fugitive emissions which includes the paving of all normally traveled roadways within the plant boundary and enclosing or hooding material transfer points.
(6) Source testing. To demonstrate compliance with this chapter, refer to WAC 173-400-105.

Wash. Admin. Code § 173-434-130

Statutory Authority: RCW 70.94.331 and 70.94.510. 04-01-159 (Order 02-05), § 173-434-130, filed 12/22/03, effective 1/22/04. Statutory Authority: RCW 70.94.331. 90-19-062 (Order 90-10), § 173-434-130, filed 9/17/90, effective 10/18/90. Statutory Authority: Chapter 70.94 RCW. 87-07-041 (Order 86-38), § 173-434-130, filed 3/16/87.