6 Va. Admin. Code § 15-81-1110

Current through Register Vol. 41, No. 8, December 2, 2024
Section 6VAC15-81-1110 - Security sealants
A. General.
1. Security sealants shall be either elastomeric (tamper resistant: hardness 50 or greater) or low-mod gel (pick-resistant: hardness 70 or greater) type.
a. Tamper resistant sealants shall be provided within all inmate occupied areas subject to continuous supervision.
b. Pick resistant sealants shall be provided within all inmate occupied areas not subject to continuous supervision, such as cells.
2. Where open joints exceed security sealant capabilities to provide a full seal, a metal cover shall be provided with security sealant at its full perimeter.
3. Tamper resistant sealant with range of movements suitable for the application shall be used. Pick resistant sealant shall not be used in movable building joints.
4. Joints above ceilings, those covered by expansion joint covers or otherwise concealed are excluded from requirements for security sealants.
5. Security sealants shall be installed with a primer and in accordance with manufacturer written recommendations.
B. Inmate occupied areas.
1. Tamper resistant sealant shall be provided as transition between surface applied floor finish and transition to wall face in lieu of an applied wall base.
2. Within all cells, pick resistant sealants shall be provided for gaps and open joints at the perimeter of all permanent materials, furnishings, fixtures, and devices.
3. Tamper resistant sealant shall be provided for gaps and open joints in other than inmate cells at the perimeter of all fixtures and devices that are removable if not designed to be continuously supervised.
4. Locations for application of tamper resistant sealant include the following:
a. Dayrooms.
b. Visitation (inmate side).
c. Classrooms.
d. Indoor recreation and multipurpose rooms.
e. Inmate toilets, lavatories, and shower areas.
5. Security sealant is not required higher than 12 feet above the finished floor or beyond six feet horizontally of guard rails enclosing tier floor and landing levels in dayrooms.

6 Va. Admin. Code § 15-81-1110

Derived From Virginia Register Volume 34, Issue 12, eff. 3/8/2018.

Statutory Authority: 53.1-5, 53.1-80, and 53.1-82 of the Code of Virginia.