Section R708-31-5 - Minimum System Requirements(1) For each system submitted for certification the manufacturer shall include: (a) a system that will record at a minimum: (i) each start attempt and outcome including override if applicable;(ii) a description and results of calibration checks;(iii) any attempts at circumvention;(iv) any attempts at tampering;(v) the breath alcohol content for each start attempt;(vi) the date and time of each attempt; and (vii) chronological order of each entry; and(b) a camera as outlined in Section R708-31-8.(2) The manufacturer shall ensure: (a) captured data is reported to the division in a manner described by the division;(b) login credentials to access system data are provided to the division upon request and at no cost;(c) captured is retained for four years from the date the system is removed from any vehicle; and(d) additional reports requested by the division are provided in a format acceptable to and at no cost to the division.(3) The division may:(a) conduct testing on any systems submitted for certification. The manufacturer or provider shall provide at no cost at least one fully functional sample of each system upon request of the division; and(b) in its discretion, retain systems provided regardless of whether the system is no longer the current version or model of that system.(4) The division may also select any system in Utah to conduct testing according to Section R708-31-4.(5) The division may require recertification of an existing certified system that has been modified.(6)(a) The manufacturer shall notify the division not less than 30 days before implementation of any modification, upgrade, or alteration to any hardware of a system certified for use in this state.(b) The notification shall include the following:(i) a description and explanation of the modification, upgrade, or alteration and proof satisfactory to the division that these modifications, upgrades, or alterations do not adversely affect the ability of the system to satisfy the requirements of this rule and Section 41-6a-518; and(ii) a comprehensive plan of action for the phasing out of the use of the current system.(10) Each existing certified manufacturer shall obtain accreditation of the ISO 9001 Quality Management System no later than October 31, 2024.(11)(a) Systems not meeting certification standards contained in this rule may not be used or installed in Utah after October 31, 2024.(b) Systems in use before October 31, 2024 may remain in use until the next monitoring appointment that occurs after October 31, 2024.Utah Admin. Code R708-31-5
Adopted by Utah State Bulletin Number 2024-06, effective 3/12/2024