Utah Admin. Code 708-2-13

Current through Bulletin No. 2024-21, November 1, 2024
Section R708-2-13 - Commercial Driver Training Vehicles
(1) Commercial driver training vehicles used for behind-the-wheel instruction shall be properly registered, maintained and clean, in safe mechanical condition, and equipped with the following:
(a) functioning dual-control brakes;
(b) outside and inside mirrors for the driver to observe rearward;
(c) inside mirror for the instructor to observe rearward;
(d) a separate seat belt for each occupant;
(e) functioning heaters and defrosters; and
(f) a functioning fire extinguisher, first aid kit, safety flares, spare tire with jack and or self-inflating tire, and reflectors that are readily accessible.
(2) Students shall receive instruction in either standard shift or automatic transmission vehicles. The commercial driver training school shall have the option of choosing the type of transmission.
(3) If instruction is given in snow or on icy road surfaces, tire chains, all season radial tires, or snow tires shall be used in compliance with local police or highway patrol recommendations.
(4) Failure to maintain a vehicle in safe operating condition is grounds for the revocation of a school license and the vehicle will be placed out of service immediately. When deemed necessary by the division, safety testing of the vehicle may be required. The school will be responsible for any costs that may be assessed.
(5) Vehicles unable to meet safety standards shall be replaced by the school.
(6) It is the responsibility of the school to notify the division of any vehicle added to or deleted from their fleet. A vehicle shall not be used for driver training or testing until it passes inspection by the division.
(7) Each vehicle used by a school for driver training or testing shall be properly identified to safeguard against accidents. A vehicle is properly identified when the words 'STUDENT DRIVER" are displayed on the front and rear and on both the left and right sides of the vehicle. The letters shall be at least three inches in height.
(8) Advertising or other markings on the vehicle for identifying or advertising the commercial driver training school shall be approved by the division and shall not distract from the words 'STUDENT DRIVER".
(9) Each school shall maintain insurance coverage on each vehicle used for driver training or testing as required under Section R708-2-4.

Utah Admin. Code R708-2-13

Adopted by Utah State Bulletin Number 2021-24, effective 12/9/2021