Section R313-30-8 - Calibration and Check of Survey Instruments and Dosimetry Equipment(1) The registrant shall ensure that the survey instruments used to show compliance with R313-30 have been calibrated before first use, at intervals not to exceed 12 months, and following repair.(2) To satisfy the requirements of R313-30-8(1), the registrant shall: (a) Calibrate required scale readings up to 10 mSv (1000 mrem) per hour with an appropriate radiation source that is traceable to the National Institute of Standards and Technology (NIST);(b) Calibrate at least two points on the scales to be calibrated. These points should be at approximately 1/3 and 2/3 of scale rating; and(3) To satisfy the requirements of R313-30-8(2), the registrant shall: (a) Consider a point as calibrated if the indicated dose rate differs from the calculated dose rate by not more than ten percent; and(b) Consider a point as calibrated if the indicated dose rate differs from the calculated dose rate by not more than 20 percent if a correction factor or graph is conspicuously attached to the instrument.(4) The registrant shall retain a record of calibrations required in R313-30-8(1) for three years. The record shall include: (a) A description of the calibration procedure; and(b) A description of the source used and the certified dose rates from the source, and the rates indicated by the instrument being calibrated, the correction factors deduced from the calibration data, the signature of the individual who performed the calibration, and the date of calibration.(5) The registrant may obtain the services of individuals licensed by the Board, the U.S. Nuclear Regulatory Commission, an Agreement State, or a Licensing State to perform calibrations of survey instruments. Records of calibrations which contain information required by R313-30-8(4) shall be maintained by the registrant.(6) Dosimetry Equipment. (a) The registrant shall have a calibrated dosimetry system available for use. The system shall have been calibrated for by the National Institute for Standards and Technology (NIST) or by an American Association of Physicists in Medicine (AAPM) Accredited Dosimetry Calibration Laboratory (ADCL). The calibration shall have been performed within 24 months prior to use and after servicing that may have affected system calibration. (i) For beams with energies greater than 1 MV (1 MeV), the dosimetry system shall have been calibrated for Cobalt-60;(ii) For beams with energies equal to or less than 1 MV (1 MeV), the dosimetry system shall have been calibrated at an energy or energy range appropriate for the radiation being used.(b) The registrant shall have available for use a dosimetry system for quality assurance check measurements. To meet this requirement, the system may be compared with a system that has been calibrated in accordance with R313-30-8(6)(a). This comparison shall have been performed within the previous 12 months (six months if the dosimetry system is an ionization chamber) and after servicing that may have affected system calibration. The quality assurance check system may be the same system used to meet the requirement in R313-30-8(6)(a);(c) The registrant shall maintain a record of dosimetry system calibration, intercomparison, and comparison for the duration of the license and registration. For calibrations, intercomparisons, or comparisons, the record shall include the date, the model numbers and serial numbers of the instruments that were calibrated, intercompared, or compared as required by R313-30-8(6)(a) and R313-30-8(6)(b), the correction factors that were determined, the names of the individuals who performed the calibration, intercomparison, or comparison, and evidence that the calibration, intercomparison, or comparison was performed by, or under the direct supervision of, a Radiation Therapy Physicist.Utah Admin. Code R313-30-8