Section R313-16-270 - Transferor, Assembler, or Installer Obligation(1) Persons who sell, lease, transfer, lend, dispose, assemble, or install a radiation machine in this state shall notify the Director within 14 working days of the following: (a) the name and address of the person who received the machine and also the name and address of the new registrant of the machine if not the same;(b) the manufacturer, model, and serial number of the master control of the radiation machine and the number of x-ray tubes transferred; and(c) the date of transfer of the radiation machine.(2) Radiation machine equipment or accessories shall not be installed if the equipment will not meet the requirements of these rules when installation is completed.(3) Reporting Compliance. Assemblers who install one or more components into a radiation machine system or subsystem, shall certify that the equipment meets the standards of these rules. A copy of this certification shall be transmitted to the purchaser and to the Director within 14 working days following the completion of the installation.(4) Certification can be accomplished by providing the following in conjunction with the information required by Section R313-16-250 and Subsection R313-16-270(1): (a) the full name and address of the assembler and the date of assembly or installation;(b) a statement as to whether the equipment is a replacement for other equipment, in addition to other equipment, or new equipment in a new facility;(c) an affirmation that the applicable rules have been met;(d) a statement of the type and intended use of the radiation machine system or subsystem, for example "radiographic-stationary general purpose x-ray;" and(e) a list of the components which were assembled or installed into the radiation machine system or subsystem, identifying the components by type, manufacturer, model number, and serial number.Utah Admin. Code R313-16-270