Section R309-511-5 - Requirements for the Hydraulic ModelThe following minimum requirements must be incorporated into hydraulic models that are constructed to meet these requirements:
(1) include at least 80 percent of the total pipe lengths in the distribution system affected by the proposed project;(2) account for 100 percent of the flow in the distribution system affected by the proposed project. Water demand allocation must account for at least 80 percent of the flow delivered by the distribution system affected by the proposed project if customer usage in the system is metered;(3) include all 8-inch diameter and larger pipes. Pipes smaller than 8-inch diameter shall also be included if they connect pressure zones, storage facilities, major demand areas, pumps, and control valves, or if they are known or expected to be significant conveyers of water such as fire suppression demand. Model piping does not need to include service lateral piping;(4) include all pipes serving areas at higher elevations, dead ends, remote areas of a distribution system, and areas with known under-sized pipelines;(5) include all storage facilities and accompanying controls or settings applied to govern the open/closed status of the facility that reflect standard operations;(6) if applicable, include all pump stations, drivers (constant or variable speed), and accompanying controls or settings applied to govern their on/off/speed status that reflect various operating conditions and drivers;(7) include all control valves or other system features that could significantly affect the flow of water through the distribution system (e.g., interconnections with other systems and pressure reducing valves between pressure zones) reflecting various operating conditions;(8) impose peak day and peak instantaneous demands to the water system's facilities. These demands may be peak day and peak instantaneous demands per R309-510, the reduced demand approved by the Director per R309-510-5, or the demands experienced by the water system that are higher than the values listed in R309-510. This may require multiple model simulations to account for the varying water demand conditions. In some cases, extended period simulations are needed to evaluate changes in operating conditions over time. This will depend on the complexity of the water system, extent of anticipated fire event and nature of the new expansion;(9) calibrate the model to adequately represent the actual field conditions using field measurements and observations;(10) if fire hydrants are connected to the distribution system, account for fire suppression requirements specified by local fire authority or use the default values stated in R309-510-9(4). For significant fire suppression demand, extended simulations must contain the run time for the period of the anticipated fire event. In some cases, a steady-state model may be sufficient for residential fire suppression demand; and,(11) account for outdoor use, such as irrigation, if the drinking water system supplies water for outdoor use.Utah Admin. Code R309-511-5