Section R307-201-3 - Visible Emissions Standards(1) Visible emissions from installations constructed on or before April 25, 1971, except diesel engines, shall be of a shade or density no darker than 40% opacity, except as otherwise provided in these rules. (2) Visible emissions from installations constructed after April 25, 1971, except diesel engines shall be of a shade or density no darker than 20% opacity, except as otherwise provided in these rules. (3) Visible emissions for all incinerators, no matter when constructed, shall be of shade or density no darker than 20% opacity. (4) No owner or operator of a gasoline powered engine or vehicle shall allow, cause or permit visible emissions. (5) Emissions from diesel engines, except locomotives, manufactured after January 1, 1973, shall be of a shade or density no darker than 20% opacity, except for starting motion no farther than 100 yards or for stationary operation not exceeding three minutes in any hour. (6) Emissions from diesel engines manufactured before January 1, 1973, shall be of a shade or density no darker than 40% opacity, except for starting motion no farther than 100 yards or for stationary operation not exceeding three minutes in any hour. (7) Visible emissions exceeding the opacity standards for short time periods as the result of initial warm-up, soot blowing, cleaning of grates, building of boiler fires, cooling, etc., caused by start-up or shutdown of a facility, installation or operation, or unavoidable combustion irregularities which do not exceed three minutes in length (unavoidable combustion irregularities which exceed three minutes in length must be handled in accordance with R307-107), shall not be deemed in violation provided that the director finds that adequate control technology has been applied. The owner or operator shall minimize visible and non-visible emissions during start-up or shutdown of a facility, installation, or operation through the use of adequate control technology and proper procedures. (8) Compliance Method. Emissions shall be brought into compliance with these requirements by reduction of the total weight of pollutants discharged per unit of time rather than by dilution of emissions with clean air. (9) Opacity Observation. Opacity observations of emissions from stationary sources shall be conducted in accordance with EPA Method 9. Opacity observers of mobile sources and intermittent sources shall use procedures similar to Method 9, but the requirement for observations to be made at 15 second intervals over a 6-minute period shall not apply. Utah Admin. Code R307-201-3
Amended by Utah State Bulletin Number 2016-1, effective 12/15/2015