Statutes, codes, and regulations
South Dakota Administrative Rules
Title 20 - PUBLIC SAFETYArticle 20:54 - STATE PLUMBING CODE
Chapter 20:54:22 - Water conditioning joints
Section 20:54:22:02 - Types of joints

S.D. Admin. R. 20:54:22:02

Download
PDF
Current through Register Vol. 51, page 67, December 16, 2024
Section 20:54:22:02 - Types of joints

Types of joints shall conform to the following standards:

(1) Threaded joints or screwed joints must conform to section 605.1.5 of the Uniform Plumbing Code, 2015 edition;
(2) Soldered or sweat joints for tubing must conform to section 605.1.4 of the Uniform Plumbing Code, 2015 edition;
(3) Flared joints for soft-copper water tubing must conform to section 605.1.2 of the Uniform Plumbing Code, 2015 edition;
(4) ABS and PVC pipe shall be joined by either threaded or solvent weld type fittings or a flexible neoprene compression gasket approved by the administrative authority. No threaded joint may be made on schedule 40 pipe. Polyethylene pipe shall be joined either by serrated insert and clamp type fittings with all clamping bands and tightening screws made of stainless steel or flared with compression fitting.

S.D. Admin. R. 20:54:22:02

SL 1975, ch 16; 42 SDR 31, effective 9/12/2016

General Authority: SDCL 36-25-14, 36-25-15. ,

Law Implemented: SDCL 36-25-15.

Uniform Plumbing Code, 2015 edition, International Association of Plumbing and Mechanical Officials. Copies may be obtained from the International Association of Plumbing and Mechanical Officials; 5001 East Philadelphia Street, Ontario, CA 91761. Cost $143.