Current through Register Vol. 54, No. 50, December 14, 2024
Section 212.106 - Additional warrants for Stop Signs (R1-1) and Yield Signs (R1-2)(a)Through highways. The Department and local authorities may designate highways as through highways to permit more continuous movement and less delay to the major flow of traffic. (1) Stop Signs (R1-1) or Yield Signs (R1-2) may be installed at all approaches to the through highway to provide preferential right-of-way at intersections.(2) The designation of a highway as a through highway does not prevent modification of the right-of-way assignment at intersections of the through highway.(3) The justification for the modification at a particular intersection will be based on the warrants in the MUTCD and the additional warrants in subsection (b), (c) or (d).(b)Stop Signs (R1-1) at intersections. In addition to the warrants for stop signs in the MUTCD (relating to stop sign applications), a Stop Sign (R1-1) may be installed on a channelized right-turn roadway at a signalized intersection where the traffic-control signals are not readily visible, and the right-turn roadway does not have separate signals, and a Yield Sign (R1-2) is not appropriate.(c)Multiway stop applications. In addition to the criteria and options warranting multiway stop applications in the MUTCD, the following apply: (1) The five or more reported crashes in a 12-month period for Warrant B may include both reportable crashes, and nonreportable crashes that are documented in the police files, that occurred during a 12-month period during the most recent 3 years of available crash data.(2) Multiway stop applications may not be used because of limited available corner sight distance unless there is no practical method of improving the sight distance or reducing the speed limit to satisfy the minimum corner sight distance values.(d)Stop and yield control at locations other than intersections. (1)One-lane bridges and underpasses. Stop Signs (R1-1) are warranted in advance of a one-lane bridge or underpass when roadway geometry is such that drivers cannot see an approaching vehicle in sufficient time for both vehicles to stop prior to entering the bridge or underpass. If sight distance is not a problem, a Yield Sign (R1-2) with the supplemental To Oncoming Traffic Sign (R1-2a) may be installed at both ends of a one-lane bridge or underpass.(2)Crossings. Stop Signs (R1-1) may be installed on highways on a temporary basis at officially designated crossings such as construction haul roads. These Stop Signs (R1-1) should only be visible and in effect during the time periods the crossing is being used and should be supplemented with a flashing red light for added visibility.(3)Private roads and driveways. Stop Signs (R1-1) or Yield Signs (R1-2) may be installed to control traffic exiting from a private road or driveway onto a highway or to control traffic on the highway at a private road or driveway if the warrants applied at highway intersections are satisfied.(4)Truck pulloffs on hazardous grades. A Stop Sign (R1-1) may be installed within an officially designated truck pull-off area in advance of a hazardous grade indicating the location that trucks are to stop within the pull-off.(5)Temporary traffic control. Stop Signs (R1-1) may be installed at both ends of short one-lane construction, maintenance or utility operation to provide self-regulating traffic control providing the one-lane section excluding the tapers is less than 250 feet, the ADT is less than 1,500, and the sight distance is sufficient.