Current through Register Vol. 54, No. 45, November 9, 2024
Section 175.64 - Braking systems(a)Condition of braking systems. Braking systems and components shall be in safe operating condition as described in § 175.80 (relating to inspection procedure).(b)Service brakes. A vehicle specified under this subchapter shall be equipped with a service brake system. See 75 Pa.C.S. § 4502 (relating to general requirements for braking systems). (1) The service brakes shall act on all wheels upon application and shall be capable of stopping a vehicle in not more than the maximum stopping distance prescribed in Table I (relating to brake performance), except on a vehicle being transported in driveaway-towaway operation.(2) The brake lining and brake fluids shall be of a type approved by the vehicle manufacturer or shall meet the Society of Automotive Engineers (SAE) standards in Appendix A (relating to minimum requirements for motor vehicle brake lining-SAE J998).(3) A passenger car manufactured or assembled after June 30, 1967, and designated as a 1968 or later model shall be equipped with a service brake system of a design that rupture or failure of either the front or rear brake system will not result in the complete loss of braking function. Braking function may be obtained by hydraulic or other means through a normal brake mechanism. In the event of a rupture or failure of an actuating force component, the unaffected brakes shall be capable of applying adequate braking force to vehicle.(4) Metal from a shoe may not contact the brake drums or rotors.(5) Brake lines shall be approved for use as brake lines.(c)Parking brake system. A vehicle specified under this subchapter shall be equipped with a parking brake system. See 75 Pa.C.S. § 4502. (1) A parking brake system shall be adequate to hold the vehicle on a surface free from ice or snow on a 20% grade with the vehicle in neutral.(2) The parking brakes shall be separately actuated so that failure of any part of the service brake actuation system will not diminish the vehicle's parking brake holding capability.The provisions of this §175.64 adopted December 2, 1977, effective 2/1/1978, 7 Pa.B. 3499; amended October 29, 1982, effective 2/1/1983, 12 Pa.B. 3862; corrected November 12, 1982, effective 2/1/1983, 12 Pa.B. 3947; readopted December 2, 1988, effective 12/3/1988, 18 Pa.B. 5362; amended November 13, 1998, effective 5/13/1999, 28 Pa.B. 5670.The provisions of this §175.64 amended under the Vehicle Code, 75 Pa.C.S. §§ 4103, 4301, 4501, 4521 and 6103.