Current through Register Vol. 54, No. 50, December 14, 2024
(a) Any existing device subject to this chapter which is damaged by fire or other causes including ordinary wear, when major repairs or replacement become necessary, shall be replaced or rebuilt in conformity with the requirements of this chapter for new construction and installation of such devices, except that it is not required that the hoistway be fireproof when the existing hoistway is used.(b) The removal and reerection of elevators, escalators, and dumbwaiters in new locations shall be in conformity with the requirements for new elevators, escalators, and dumbwaiters. Existing hoists, when used as permanent installations, may not be reerected in new locations.(c) Before work costing $1,000 or more is commenced on the repair of elevator devices, duplicate applications for such repair work shall be filed with the Department by the building owner or the elevator contractor. Before work costing $1,000 or more and involving major repairs as defined in subsection (e) is commenced on the repair of elevator devices, duplicate applications for such repair work plus a $50 fee for a permit shall be filed with the Department by the building owner or the elevator contractor and a permit covering such repairs or changes shall be obtained from the Department.(d) After work costing $1,000 or more is completed, the building owner or elevator contractor shall notify the Department and such repairs may be inspected by the Department for approval. After work costing $1,000 or more and involving major repairs as defined in subsection (e) is completed, the building owner or elevator contractor shall notify the Department and such repairs will be inspected by the Department for approval.(e) Major repairs shall include but shall not be limited to the following changes in an elevator: increase in the rated load or speed, increase in the dead weight of the car, change in travel, change in the type of operation or control, change in the size or number of suspension ropes, change in the size or type of guide rails, change in classification from freight elevator to passenger elevator, change in the power supply, change in the type of car or counterweight safety, installation of a new driving machine, installation of a new controller, installation of new brakes, replacement of hoistway doors, addition of landing door interlocks, addition of door operating devices, addition of auxiliary rope fastening devices, addition of car leveling, addition of roller guide shoes, and addition of new car or counterweight safety. As to hydraulic elevators, major repairs shall include the preceeding changes as appropriate, and shall include but shall not be limited to the following changes: installation of different control valves, replacement of existing relief and check valves, replacement of existing supply pipings and fittings, replacement of existing tanks, replacement of cylinder, replacement of plunger, and increase in the working pressure by more than 3.0%.The provisions of this § 7.13 amended December 19, 1980, effective 12/20/1980, 10 Pa.B. 4723.The provisions of this § 7.13 issued under act of May 2, 1929 (P. L. 1518, No. 452) (35 P. S. §§ 1341-1356).
This section cited in 34 Pa. Code § 7.251 (relating to general).