Current through Vol. 42, No. 7, December 16, 2024
Section 310:260-3-2 - Grounds and plants(a)Grounds. The grounds about a food plant under the control of the operator shall be kept in a condition that will protect against the contamination of food. The methods for adequate maintenance of grounds include, but are not limited to: (1) Properly storing equipment, removing litter and waste, and cutting weeds or grass within the immediate vicinity of the plant buildings or structures that may constitute an attractant, breeding place, or harborage for pests.(2) Maintaining roads, yards, and parking lots, including dust and flying debris, so that they do not constitute a source of contamination in areas where food is exposed.(3) Adequately draining areas that may contribute contamination to food by seepage, food-borne filth, or providing a breeding place for pests.(4) Operating systems for waste treatment and disposal in an adequate manner so that they do not constitute a source of contamination in areas where food is exposed.(5) If the plant grounds are bordered by grounds not under the operator's control and not maintained in the manner described in paragraph (a) (1) through (3) of this section, care shall be exercised in the plant by inspection, extermination, or other means to exclude pests, dirt, and filth that may be a source of food contamination. (b)Plant construction and design. Plant buildings and structures shall be suitable in size, construction, and design to facilitate maintenance and sanitary operations for food-manufacturing purposes (i.e., manufacturing, processing, packing, and holding). The plant and facilities shall: (1) Provide sufficient space for such placement of equipment and storage of materials as is necessary for the maintenance of sanitary operations and the production of safe food.(2) Permit the taking of adequate precautions to reduce the potential for allergen cross-contact and for contamination of food, food-contact surfaces, or food-packing materials with microorganisms, chemicals, filth, or other extraneous material. The potential for allergen cross-contact and for contamination may be reduced by adequate food safety controls and operating practices or effective design, including the separation of operations in which for allergen cross-contact and contamination are likely to occur, by one or more of the following means: location, time, partition, air flowsystems, dust control systems, enclosed systems, or other effective means. (3) Permit the taking of proper precautions to protect food in installed outdoor bulk vessels by any effective means, including: (A) Using protective coverings.(B) Controlling areas over and around the vessels to eliminate harborage for pests.(C) Checking on a regular basis for pests and pest infestation.(D) Skimming the fermentation vessels, as necessary.(4) Be constructed in such a manner that floors, walls, and ceilings may be adequately cleaned and kept in good repair; that drip or condensate from fixtures, ducts and pipes does not contaminate food, food-contact surfaces, or food packing materials; and that aisles or working spaces are provided between equipment and walls and are adequately unobstructed and of adequate width to permit employees to perform their duties and to protect against contaminating food or food-contact surfaces with clothing or personal contact.(5) Provide adequate lighting in hand washing areas, dressing and locker rooms, and toilet rooms and in all areas where food is examined, processed, packed or held and where equipment or utensils are cleaned.(6) Provide shatter-resistant light bulbs, fixtures, skylights, or other glass suspended over exposed food in any step of preparation or otherwise protect against food contamination in case of glass breakage.(7) Provide adequate ventilation or control equipment to minimize odors and vapors (including steam and noxious fumes) in areas where they may cause allergen cross-contact or contaminate food; and locate and operate fans and other air-blowing equipment in a manner that minimizes the potential for allergen cross-contact and for contaminating food, food-packaging materials, and food-contact surfaces. (8) Provide, where necessary, adequate screening or other protection against pests.(9) Provide adequate protection, from contamination, of food products, while being transported by vehicles. Okla. Admin. Code § 310:260-3-2
Amended by Oklahoma Register, Volume 37, Issue 24, September 1, 2020, eff. 9/11/2020