Okla. Admin. Code § 310:234-7-2

Current through Vol. 42, No. 7, December 16, 2024

Section 310:234-7-2 - Physical construction and maintenance

(a) All walls, floors, ceilings and all procedure surfaces where medical micropigmentation is performed shall be smooth, free of open holes or cracks, washable, in good repair, and clean. All procedure surfaces, including client chairs/benches shall be of such construction as to be easily cleaned and sanitized after each client.

(b) No animals of any kind shall be allowed in the area where medical micropigmentation is performed except service animals used by persons with disabilities.

(c) The facility shall comply with OAC 158:40 (Plumbing Industry Regulations). In addition, a separate, readily accessible, handsink with hot and cold running water, under pressure, equipped with wrist or foot operated controls and supplied with liquid soap, and disposable paper towels shall be readily accessible to each individual performing medical micropigmentation.

(d) At least one covered waste receptacle shall be provided in each medical micropigmentation area and each toilet room. All refuse containers shall be lidded, cleanable and kept clean.

(e) All instruments and supplies shall be stored in clean, dry and covered containers.

(f) Reusable cloth items shall be mechanically washed with detergent and dried after each use. The cloth items shall be stored in a dry, clean environment until used.

(g) The facility shall comply with OAC 158:40 (Electrical Industry Regulations). In addition, the medical micropigmentation room shall have 10-foot candles of light at 30 inches above the floor and 30-foot candles on surfaces where micropigmentation is performed.

(h) The facility shall comply with OAC 158:50 (Mechanical Industry Regulations).

Okla. Admin. Code § 310:234-7-2

Added at 19 Ok Reg 378, eff 11-19-01 (emergency); Added at 19 Ok Reg 2067, eff 6-27-02; Amended at 24 Ok Reg 1177, eff 4-2-07 (emergency); Amended at 24 Ok Reg 1940, eff 6-25-07