Okla. Admin. Code § 165:15-3-16

Current through Vol. 42, No. 7, December 16, 2024

Section 165:15-3-16 - Inspection for compliance

(a) Retail liquid measuring devices subject to the rules of this Chapter are calibrated with a five (5) gallon test measure by the Fuel Specialist from time to time or as often as deemed necessary. High volume dispensers (those that are used to pump at a rate of at least twenty (20) gallons per minute) used to fill large tanks must be calibrated using a fifty (50) or one hundred (100) gallon prover.

(b) All wholesale liquid measuring devices subject to the rules of this Chapter must be calibrated before ten (10) million gallons of use, or more often if PSTD deems it necessary.

(c) Before a new facility is open for business and before new dispensers are put into service at a pre-existing facility, the owner or operator must have the dispensers calibrated and be able to show written proof when requested by the Fuel Specialist.

(d) These tests may be ordered or directed by the Commission at any time.

(e) When a liquid measuring device is found not to be in compliance with this Chapter, the owner or operator will be advised of the problem and the device placed out of service.

(f) A Fuel Specialist has the responsibility to place or to direct that a lock or seal be placed on a measuring device. The lock or seal must remain in place until the defective measuring device is repaired or replaced and complies with Commission standards, rules, and requirements.

Okla. Admin. Code § 165:15-3-16

Amended at 18 Ok Reg 1052, eff 5-11-01; Amended at 21 Ok Reg 2029, eff 7-1-04; Amended at 23 Ok Reg 1650, eff 7-1-06

Amended by Oklahoma Register, Volume 32, Issue 23, August 17, 2015, eff. 8/27/2015

Amended by Oklahome Register, Volume 33, Issue 23, August 15, 2016, eff. 8/25/2016

Amended by Oklahoma Register, Volume 34, Issue 24, September 1, 2017, eff. 9/11/2017

Amended by Oklahoma Register, Volume 35, Issue 24, September 4, 2018, eff. 10/1/2018