Section 3745-76-11 - Monitoring of operationsExcept as provided in paragraph (B)(2)(a)(ii) of rule 3745-76-07 of the Administrative Code,
(A) Each owner or operator seeking to comply with paragraph (B)(2)(b)(i) of rule 3745-76-07 of the Administrative Code for an active gas collection system shall install a sampling port and a thermometer, other temperature measuring device, or an access port for temperature measurements at each wellhead and: (1) Measure the gauge pressure in the gas collection header on a monthly basis as provided in paragraph (A)(3) of rule 3745-76-10 of the Administrative Code; and(2) Monitor nitrogen or oxygen concentration in the landfill gas on a monthly basis as provided in paragraph (A)(5) of rule 3745-76-10 of the Administrative Code; and(3) Monitor temperature of the landfill gas on a monthly basis as provided in paragraph (A)(5) of rule 3745-76-10 of the Administrative Code.(B) Each owner or operator seeking to comply with paragraph (B)(2)(c) of rule 3745-76-07 of the Administrative Code using an enclosed combustor shall calibrate, maintain, and operate according to the manufacturer's specifications, the following equipment. (1) A temperature monitoring device equipped with a continuous recorder and having a minimum accuracy of plus or minus one percent of the temperature being measured expressed in degrees Celsius or plus or minus 0.5 degrees Celsius, whichever is greater. A temperature monitoring device is not required for boilers or process heaters with design heat input capacity equal to or greater than forty four megawatts.(2) A device that records flow to or bypass of the control device. The owner or operator shall either: (a) Install, calibrate, and maintain a gas flow rate measuring device that shall record the flow to the control device at least every fifteen minutes; or(b) Secure the bypass line valve in the closed position with a car-seal or a lock-and-key type configuration. A visual inspection of the seal or closure mechanism shall be performed at least once every month to ensure that the valve is maintained in the closed position and that the gas flow is not diverted through the bypass line.(C) Each owner or operator seeking to comply with paragraph (B)(2)(c) of rule 3745-76-07 of the Administrative Code using an open flare shall install, calibrate, maintain, and operate according to the manufacturer's specifications the following equipment: (1) A heat sensing device, such as an ultraviolet beam sensor or thermocouple, at the pilot light or the flame itself to indicate the continuous presence of a flame.(2) A device that records flow to or bypass of the flare. The owner or operator shall either: (a) Install, calibrate, and maintain a gas flow rate measuring device that shall record the flow to the control device at least every fifteen minutes; or(b) Secure the bypass line valve in the closed position with a car-seal or a lock-and-key type configuration. A visual inspection of the seal or closure mechanism shall be performed at least once every month to ensure that the valve is maintained in the closed position and that the gas flow is not diverted through the bypass line.(D) Each owner or operator seeking to demonstrate compliance with paragraph (B)(2)(c) of rule 3745-76-07 of the Administrative Code using a device other than an open flare or an enclosed combustor shall provide information satisfactory to the director as provided in paragraph (B)(2)(a)(ii) of rule 3745-76-07 of the Administrative Code describing the operation of the control device, the operating parameters that would indicate proper performance, and appropriate monitoring procedures. The director shall review the information and either approve it, or request that additional information be submitted. The director may specify additional appropriate monitoring procedures.(E) Each owner or operator seeking to install a collection system that does not meet the specifications in rule 3745-76-14 of the Administrative Code or seeking to monitor alternative parameters to those required by rule 3745-76-08 to rule 3745-76-11 of the Administrative Code shall provide information satisfactory to the director as provided in paragraph (B)(2)(a)(ii) of rule 3745-76-07 of the Administrative Code and paragraph (B)(2)(a)(iii) of rule 3745-76-07 of the Administrative Code describing the design and operation of the collection system, the operating parameters that would indicate proper performance, and appropriate monitoring procedures. The director may specify additional appropriate monitoring procedures.(F) Each owner or operator seeking to demonstrate compliance with paragraph (C) of rule 3745-76-10 of the Administrative Code, shall monitor surface concentrations of methane according to the instrument specifications and procedures provided in paragraph (D) of rule 3745-76-10 of the Administrative Code. Any closed landfill that has no monitored exceedances of the operational standard in three consecutive quarterly monitoring periods may skip to annual monitoring. Any methane reading of five hundred parts per million or more above background detected during the annual monitoring returns the frequency for that landfill to quarterly monitoring. Ohio Admin. Code 3745-76-11
Five Year Review (FYR) Dates: 03/24/2016 and 03/24/2021
Promulgated Under: 119.03
Statutory Authority: 3704.04(E)
Rule Amplifies: 3704.03(A), 3704.;03(E)
Prior Effective Dates: 1/31/98, 11/16/99, 10/10/06R.C. 119.032 review dates: 06/16/2011 and 06/16/2016
Promulgated Under: 119.03
Statutory Authority: 3704.03(E)
Rule Amplifies: 3704.03(A), 3704.03(E)
Prior Effective Dates: 1/31/98, 11/16/99, 10/10/06