N.M. Admin. Code § 20.6.2.5354

Current through Register Vol. 35, No. 23, December 10, 2024

Section 20.6.2.5354 - CORRECTIVE ACTION FOR WELLS IN THE AREA OF REVIEW

For the purposes of Class I hazardous waste wells, this section shall apply to the exclusion of 20.6.2.5203 NMAC.

A. The owner or operator of a Class I hazardous waste well shall as part of the permit application submit a plan to the director outlining the protocol used to:

(1) identify all wells penetrating the confining zone or injection zone within the area of review; and

(2) determine whether wells are adequately completed or plugged.

B. The owner or operator of a Class I hazardous waste well shall identify the location of all wells within the area of review that penetrate the injection zone or the confining zone and shall submit as required in Subsection A of 20.6.2.5360 NMAC:

(1) a tabulation of all wells within the area of review that penetrate the injection zone or the confining zone; and

(2) a description of each well or type of well and any records of its plugging or completion.

C. For wells that the director determines are improperly plugged, completed, or abandoned, or for which plugging or completion information is unavailable, the applicant shall also submit a plan consisting of such steps or modification as are necessary to prevent movement of fluids into or between groundwater of the state of New Mexico. Where the plan is adequate, the director shall incorporate it into the permit as a condition. Where the director's review of an application indicates that the permittee's plan is inadequate (based at a minimum on the factors in Subsection E of this section), the director shall:

(1) require the applicant to revise the plan;

(2) prescribe a plan for corrective action as a condition of the permit; or

(3) deny the application.

D. Requirements.

(1) Existing injection wells. Any permit issued for an existing Class I hazardous waste injection well requiring corrective action other than pressure limitations shall include a compliance schedule requiring any corrective action accepted or prescribed under Subsection C of this section. Any such compliance schedule shall provide for compliance no later than two years following issuance of the permit and shall require observance of appropriate pressure limitations under Paragraph (3) of Subsection D until all other corrective action measures have been implemented.

(2) New injection wells. No owner or operator of a new Class I hazardous waste injection well may begin injection until all corrective actions required under this section have been taken.

(3) The director may require pressure limitations in lieu of plugging. If pressure limitations are used in lieu of plugging, the director shall require as a permit condition that injection pressure be so limited that pressure in the injection zone at the site of any improperly completed or abandoned well within the area of review would not be sufficient to drive fluids into or between groundwater of the state of New Mexico. This pressure limitation shall satisfy the corrective action requirement. Alternatively, such injection pressure limitation may be made part of a compliance schedule and may be required to be maintained until all other required corrective actions have been implemented.

E. In determining the adequacy of corrective action proposed by the applicant under Subsection C of this section and in determining the additional steps needed to prevent fluid movement into and between groundwater of the state of New Mexico, the following criteria and factors shall be considered by the director:

(1) nature and volume of injected fluid;

(2) nature of native fluids or by products of injection;

(3) geology;

(4) hydrology;

(5) history of the injection operation;

(6) completion and plugging records;

(7) closure procedures in effect at the time the well was closed;

(8) hydraulic connections with groundwater of the state of New Mexico;

(9) reliability of the procedures used to identify abandoned wells; and

(10) any other factors which might affect the movement of fluids into or between groundwater of the state of New Mexico.

N.M. Admin. Code § 20.6.2.5354

Adopted by New Mexico Register, Volume XXVI, Issue 15, August 14, 2015, eff. 8/31/2015