Current through Register Vol. 35, No. 23, December 10, 2024
Section 20.6.2.4106 - ABATEMENT PLAN PROPOSALA. Except as provided for in Section 20.6.2.4105 NMAC, a responsible person shall, within sixty (60) days of receipt of written notice from the secretary that an abatement plan is required, submit an abatement plan proposal to the secretary for approval. For good cause shown, the secretary may allow for a total of one hundred and twenty (120) days to prepare and submit the abatement plan proposal.B.Voluntary Abatement: (1) Any person wishing to abate water pollution in excess of the standards and requirements set forth in Section 20.6.2.4103 NMAC may submit a Stage 1 abatement plan proposal to the secretary for approval. Following approval by the secretary of a final site investigation report prepared pursuant to Stage 1 of an abatement plan, any person may submit a Stage 2 abatement plan proposal to the secretary for approval.(2) Following approval of a Stage 1 or Stage 2 abatement plan proposal under Paragraph (1) of Subsection B of this Section, the person submitting the approved plan shall be a responsible person under Sections 20.6.2.4000 through 20.6.2.4115 NMAC for the purpose of performing the approved Stage 1 or Stage 2 abatement plan. Nothing in this Section shall preclude the secretary from applying Paragraph (9) of Subsection A of Section 20.6.2.1203 NMAC to a responsible person if applicable.C.Stage 1 Abatement Plan: The purpose of Stage 1 of the abatement plan shall be to design and conduct a site investigation that will adequately define site conditions, and provide the data necessary to select and design an effective abatement option. Stage 1 of the abatement plan may include, but not necessarily be limited to, the following information depending on the media affected, and as reasonably needed to select and implement an expeditious abatement option: (1) Descriptions of the site, including a site map, and of site history including the nature of the discharge that caused the water pollution, and a summary of previous investigations;(2) Site investigation workplan to define: (a) site geology and hydrogeology, the vertical and horizontal extent and magnitude of vadose-zone and ground water contamination, subsurface hydraulic parameters including hydraulic conductivity, transmissivity, storativity, and rate and direction of contaminant migration, inventory of water wells inside and within one (1) mile from the perimeter of the three-dimensional body where the standards set forth in Subsection B of Section 20.6.2.4103 NMAC are exceeded, and location and number of such wells actually or potentially affected by the pollution; and(b) surface water hydrology, seasonal stream flow characteristics, ground water/surface water relationships, the vertical and horizontal extent and magnitude of contamination and impacts to surface water and stream sediments. The magnitude of contamination and impacts on surface water may be, in part, defined by conducting a biological assessment of fish, benthic macroinvertebrates and other wildlife populations. Seasonal variations should be accounted for when conducting these assessments.(3) Monitoring program, including sampling stations and frequencies, for the duration of the abatement plan that may be modified, after approval by the secretary, as additional sampling stations are created;(4) Quality assurance plan, consistent with the sampling and analytical techniques listed in Subsection B of Section 20.6.2.3107 NMAC and with Section 20.6.4.10 NMAC of the Water Quality Standards for Interstate and Intrastate Streams in New Mexico (20.6.4 NMAC), for all work to be conducted pursuant to the abatement plan;(5) Site health and safety plan for all work to be performed pursuant to the abatement plan;(6) A schedule for all Stage 1 abatement plan activities, including the submission of summary quarterly progress reports, and the submission, for approval by the secretary, of a detailed final site investigation report; and(7) Any additional information that may reasonably be required to design and perform an adequate site investigation.D.Stage 2 Abatement Plan: Any responsible person shall submit a Stage 2 abatement plan proposal to the secretary for approval within sixty (60) days after approval by the secretary of the final site investigation report prepared pursuant to Stage 1 of the abatement plan. The secretary may grant approval for an extension of time to submit a State 2 abatement plan for good cause shown.E. The purpose of Stage 2 of the abatement plan shall be to select and design, if necessary, an abatement option that, when implemented, will result in attainment of the abatement standards and requirements set forth in Section 20.6.2.4103 NMAC, including post-closure maintenance activities. Stage 2 of the abatement plan should include, at a minimum, the following information: (1) Brief description of the current situation at the site;(2) Development and assessment of abatement options;(3) Description, justification and design, if necessary, of preferred abatement option;(4) Modification, if necessary, of the monitoring program approved pursuant to Stage 1 of the abatement plan, including the designation of pre and post abatement-completion sampling stations and sampling frequencies to be used to demonstrate compliance with the standards and requirements set forth in Section 20.6.2.4103 NMAC;(5) Site maintenance activities, if needed, proposed to be performed after termination of abatement activities;(6) A schedule for the duration of abatement activities, including the submission of summary quarterly progress reports;(7) A public notification proposal designed to satisfy the requirements of Subsections B and C of Sections 20.6.2.4108 and 20.6.2.4108 NMAC; and(8) Any additional information that may be reasonably required to select, describe, justify and design an effective abatement option.N.M. Admin. Code § 20.6.2.4106
12-1-95; 20.6.2.4106 NMAC - Rn, 20 NMAC 6.2.IV.4106, 1-15-01, Amended by New Mexico Register, Volume XXIX, Issue 23, December 11, 2018, eff. 12/21/2018