N.M. Admin. Code § 19.2.10.12

Current through Register Vol. 35, No. 23, December 10, 2024

Section 19.2.10.12 - SURVEY PLAT

A. Unless waived by the commissioner pursuant to 19.2.10.13 NMAC, each application for an easement or right of way shall include a survey plat, which describes the location (by quarter-section parts or lots, township, and range coordinates) of the proposed easement or right of way. The survey plat shall be based upon an actual survey on the ground and shall include a plat prepared in accordance with the Minimum Standards for Surveying in New Mexico as set out by the New Mexico board of registration for professional engineers and surveyors, by a professional surveyor who is registered in New Mexico or exempt from registration under the provisions of the Engineering and Surveying Practice Act, Sections 61-23-1 to -32 NMSA 1978, or its successor provisions. The survey plat shall be properly certified showing the surveyor's state of registration and registration number. The survey plat shall show the centerline of the proposed easement or right of way or, if there is no centerline, then the area of the proposed easement or right of way. The survey plat shall identify every point where the proposed easement or right of way enters or leaves state trust land, crosses a section line, fence, road, pipeline, telephone line, irrigation works, or any other visible boundary, use, or easement. The survey plat shall show the location of all improvements in the close proximity of the easement or right of way. The survey plat shall show ties to section and quarter section corners, and measurements shall be to the nearest tenth of a foot with bearings expressed to the nearest minute. In no case shall the smallest unit of angular measurement be more than one minute. Acreage shall be computed to the nearest one hundredth of an acre and the survey plat shall show the number of acres, and the number of rods, included in the proposed easement or right of way in each legal subdivision of 40 acres, more or less.

B. When the requirement to submit a survey plat in accordance with Subsection A of 19.2.10.12 NMAC has been waived pursuant to 19.2.10.13 NMAC, then the applicant must provide to the commissioner a plat (prepared by the applicant, or the applicant's designated agent), drawn to scale, and showing the location of the easement or right of way and indicating the approximate number of acres and rods to be taken, as well as the legal description (by quarter-section parts or lots, township, and range coordinates) of the lands to be burdened by the proposed easement or right of way in the form required by Subsection A of 19.2.10.12 NMAC.

19.2.10.12 NMAC - Rp, 19.2.10.12 NMAC, 06/30/04, Amended by New Mexico Register, Volume XXX, Issue 11, June 11, 2019, eff. 6/11/2019