Statutes, codes, and regulations
New Jersey Administrative Code
Title 7 - ENVIRONMENTAL PROTECTIONChapter 27B - SAMPLING AND ANALYTICAL PROCEDURES
Subchapter 1 - SAMPLING AND ANALYTICAL PROCEDURES FOR DETERMINING EMISSIONS OF PARTICLES FROM MANUFACTURING PROCESSES AND FROM COMBUSTION OF FUELS
Section 7:27B-1.7 - General Testing Requirements

N.J. Admin. Code § 7:27B-1.7

Download
PDF
Current through Register Vol. 56, No. 19, October 7, 2024
Section 7:27B-1.7 - General Testing Requirements
(a) All tests shall be conducted in accordance with the following:
1. The sampling location and number of traverse points shall be determined by E.P.A. Method 1 (Reference 3) or ASME Power Test Code PTC-27 (Reference 4), or Western Precipitation Bulletin WP-50 (Reference 5), or ASTM Standard D2928 (Reference 6).
2. Determination of stack gas velocity shall be by E.P.A. Method 2 (Reference 3) or ASME Power Test Code PTC-27 (Reference 4), or Western Precipitation Bulletin WP-50 (Reference 5), or ASTM Standard D2928 (Reference 6).
3. Unless otherwise specified by the Department, each performance test consists of not less than three separate and valid one-hour test runs.
4. For the purpose of determining compliance with any applicable standard, the results of each valid test run (see Section 14 of this Subchapter) shall be considered.

N.J. Admin. Code § 7:27B-1.7