N.J. Admin. Code § 7:27-26.8

Current through Register Vol. 56, No. 24, December 18, 2024

Section 7:27-26.8 - Registration

(a) The manufacturer of an adhesive, sealant, adhesive primer or sealant primer who uses a date-code other than the YY DDD format as described at N.J.A.C. 7:27-26.7(b) to comply with N.J.A.C. 7:27-26.7(b) shall register that product and an explanation of the date-code with the Department as follows:

1. The registration shall include the following information:

i. The name of the manufacturer;

ii. The full mailing address of the manufacturer;

iii. The name and telephone number of a contact person;

iv. The product category and subcategory (as listed in Table 1 at 7:27-26.3) to which the manufacturer's product belongs (for example: sealants:marine deck); and

v. An explanation of the date-code system;

2. The registration shall be submitted to the Department on the form provided by the Department at http://www.state.nj.us/dep/baqp, and shall be submitted electronically, by email, on diskette, or on CD-ROM, unless:

i. Electronic submission would impose hardship on the manufacturer; and

ii. The Department is satisfied that a hardship exists and approves a written request from the manufacturer to submit the information on paper pursuant to (c) below;

3. The registration shall be submitted in accordance with the following schedule:

i.For an adhesive, sealant, adhesive primer or sealant primer sold in New Jersey prior to January 1, 2009, the registration shall be submitted on or after December 29, 2008, and prior to January 1, 2009; and

ii. For an adhesive, sealant, adhesive primer or sealant primer sold in New Jersey on or after January 1, 2009, that was not sold in New Jersey prior to January 1, 2009, the registration shall be submitted prior to selling the product in New Jersey; and

4. If, subsequent to the submission of a registration, any information provided in the registration changes, the manufacturer shall submit a revised registration including the new information within 90 days of the change.

(b) No information submitted as part of the registration may be claimed to be confidential, including under the procedures set forth at N.J.A.C. 7:27-1.6 through 1.29.

(c) If a manufacturer seeks approval to submit its registration on paper, rather than electronically, the following apply:

1. The manufacturer shall submit the written request to the following address: Department of Environmental Protection

Bureau of Air Quality Planning

401 East State Street

Mail Code 401-07H

PO Box 420

Trenton, New Jersey 08625-0420

and the envelope in which the written request is submitted shall be labeled as follows: "Attention: Request for On-Paper Submittal of Adhesives/Sealants Registration";

2. The written request shall include an explanation of the hardship that electronic submission would impose on the manufacturer;

3. Any submittal to the Department other than a registration shall be certified in accordance with N.J.A.C. 7:27-1.39, Certification of information;

4. The Department shall not approve a manufacturer's written request to submit its registration on paper unless the Department is satisfied that electronic submission would impose hardship on the manufacturer; and

5. Once the Department has approved submission of a non-electronic submission, the manufacturer shall send the submission to the address provided at (c)1 above.

N.J. Admin. Code § 7:27-26.8

Administrative change.
See: 43 N.J.R. 2328(a).