Section Eng 308.02 - Licensed Engineer Seal or Stamp(a) The board shall upon issuance of a license to an applicant as a licensed engineer, require the licensee to acquire an impression type seal or rubber stamp of the design specified by these rules. This seal shall bear the licensee's name and number as shown on the license. This seal may be affixed on all plans, maps, and reports prepared by the licensee, but shall be affixed to all documents issued or filed for public record.(b) The seal shall consist of 2 concentric circles with the outer circle having a diameter of 1-9/16 inches and the inner circle diameter 15/16 of an inch. In the space between the circles at the top shall be the words "State of New Hampshire" and at the bottom "Professional Engineer." In the space inside the inner circle shall be the full legal name of the licensee and the license number written horizontally. At the bottom of the inner circle shall be the word "Licensed."(c) It shall be a violation of these rules, pursuant to RSA 310-A:25, for the licensee to stamp or seal any documents with their seal after their license has expired, been revoked, or suspended or after the licensee has chosen retired status. It shall be a violation of these rules for the licensee to stamp or seal any documents not prepared by that licensee personally or under their direct supervision.N.H. Admin. Code § Eng 308.02
#6911, eff 12-15-98; ss by #8190, eff 10-19-04; ss by #10045, eff 1-1-12
Amended by Number 19, Filed May 9, 2024, Proposed by #13942, Effective 6/25/2024, Expires 6/25/2034.