N.H. Admin. Code § Agr 1405.34

Current through Register No. 50, December 12, 2024
Section Agr 1405.34 - Form for Placed in Service/Inspection Report for Large Volume Petroleum Measuring Devices
(a) In addition to other requirements set by rule, statute, or other law, each registered service technician shall complete and submit "Placed in Service/Inspection Report Form lg.vol 04-2005 (Rev.07/14)" to the department.
(b) A registered service technician shall furnish the following on "Placed in Service/Inspection Report Form lg.vol 04-2005 (Rev. 07/14)":
(1) Name of business;
(2) Full address, including city, state, and zip code;
(3) The following information about each large volume petroleum measuring device at the business:
a. Whether installed;
b. Whether certified;
c. Whether it replaces a prior device, and the device's serial number (SN#);
d. Whether repaired;
e. Whether tested and calibrated;
f. Whether rejected;
g. Make of meter;
h. Serial number of meter;
i. Product used to test meter;
j. Make of register; and
k. Serial number of register;
(4) The following information about each test data:
a. Type of test;
b. Actual discharge rate;
c. Totalizer reading start; and
d. Totalizer reading finish;
(5) The following information about each prover data:
a. Prover temperature;
b. Prover reading;
c. Correction for expansion/contraction of prover;
d. Volume correction for prover reading; and
e. Prover reading corrected to 60 degrees Fahrenheit;
(6) The following information about each meter data:
a. Gross meter reading; and
b. Net meter reading;
(7) If the run is an uncompensated run or systems that give both gross and net readings, the following:
a. Average meter temperature;
b. Volume correction for meter reading; and
c. Meter reading corrected to 60 degrees Fahrenheit;
(8) Net delivery error; and
(9) Correct gross delivery error.

N.H. Admin. Code § Agr 1405.34

#10168, eff 8-3-12

Amended by Volume XXXVII Number 50, Filed December 14, 2017, Proposed by #12424, Effective 12/1/2017, Expires 12/1/2027.