Current through Register Vol. 23, December 6, 2024
Rule 37.112.117 - WORK ROOM REQUIREMENTS(1) All tattooing and body piercing procedures must take place in the work room only.(2) The work room must be separated by a barrier from the waiting area. The room does not need to have complete physical separation, but it must be segregated by counters, self-closing doors, or other barriers so that clients or other employees may not enter the work room unless they open the barrier to gain access.(3) The work room may not be used as a corridor for access to other rooms.(4) Animals are not allowed in the work room, except for patrol dogs accompanying security or police officers and service animals such as guide dogs.(5) The work room must have a minimum of 50 foot-candles of light measured at the level where the procedure is implemented. Spot lighting may be used to achieve this degree of illumination.(6) The work room must have adequate ventilation.(7) Openings to the outside must be protected by such means as self-closing doors, screened or closed windows, or air currents to protect against the entrance of insects, rodents, or other animals. Screening material must not be less than 16 mesh to the inch.(8) The work rooms must have a handwashing facility unless there is a handwashing facility outside the work room within ten feet of the work room door. (a) If the handwashing facility is outside the work room, the work room door must be a two-way self-closing door.(b) The handwashing facility cannot be in the same room as the toilet.(c) If controls for wrist or foot activation are not available, single service towels must be used for turning controls off after washing hands.(d) The handwashing sink must be sanitized at least once each day while the establishment is in operation.(e) The handwashing sink must be provided with hot and cold running water by means of a mixing valve or combination faucet, except as provided in ARM 37.112.121(2) regarding temporary or mobile establishments.(f) Any self-dispensing, slow-closing, or metering faucet used must be designed to provide a flow of water for at least 20 seconds without the need to reactivate the faucet.(g) Steam mixing valves are prohibited.(h) Soap must be conveniently located near the handwashing sink.(i) Individual, disposable towels must be conveniently located for drying hands.(9) The work room must have a sufficient number of waste receptacles for the disposal of waste materials. (a) Waste receptacles must be covered except while in use to prevent contamination of hands and gloves.(b) Waste receptacles in the work room must be emptied daily.(c) A dedicated container for the disposal of sharps and a dedicated container for other contaminated waste must be located in the work room in accordance with ARM 37.112.137 for disposal of infectious material.(10) The work room must be maintained in a clean condition.(11) The floor of the work room must be constructed of smooth and impervious materials that are easily cleanable and in good condition. The floor must be wet-mopped daily.(12) Tobacco use, eating, or drinking is prohibited in the work room, except eating and drinking is allowed when needed for first aid purposes.Mont. Admin. r. 37.112.117
NEW, 2007 MAR p. 351, Eff. 3/23/07; AMD, 2013 MAR p. 156, Eff. 2/1/13.50-48-103, MCA; IMP, 50-48-103, MCA;