Mo. Code Regs. tit. 11 § 40-2.021
Current through Register Vol. 49, No. 23, December 2, 2024
Section 11 CSR 40-2.021 - Inspector/Qualifications/Examinations/ResponsibilitiesPURPOSE: This rule addresses the qualifications and responsibilities of boiler, water heater and pressure vessel inspectors.
(1) As used in this rule, the term "these rules" is intended to mean 11 CSR 40-2.010through 11 CSR 40-2.065.
(2) Identification Card Issued by Chief Inspector.(A) Each deputy and special inspector engaged in the inspection of boilers, water heaters or pressure vessels shall obtain an identification card prior to performing any inspection.(B) An identification card is valid until December 31 of the year in which it is issued and must be renewed annually. Requests for renewal shall be submitted in writing to the chief inspector prior to the expiration date.(C) An initial identification card may be obtained from the chief inspector after passing the required examination(s) and payment of fees. An examination is not required for renewal.(D) Each applicant for an initial identification card shall submit a written application and the required fee to the chief inspector at least thirty (30) days prior to the next scheduled examination, on forms furnished by the chief inspector, stating the applicant's education and work experience, including the names of current and previous employers, length of time employed by each employer and position held. The applicant shall also submit a copy of a photo identification card from the employer or a copy of a valid photo identification driver's license and a copy of the applicant's most recent national board commission.(E) An applicant shall have education and experience equal to at least one (1) of the following: 1. A degree in mechanical engineering plus one (1) year of experience in design, construction, operation or inspection of boilers or pressure vessels; or2. A degree in a branch of engineering, other than mechanical engineering or an associates degree in mechanical technology plus two (2) years of experience in design, construction, operation or inspection of boiler or pressure vessels; or3. The equivalent of a high school education plus three (3) years of experience- A. In boiler or pressure vessel construction or repair; orB. As an operating engineer in charge of high pressure boiler operation; orC. As an inspector of boilers or pressure vessels; or4. A valid commission from the national board.(F) Applicants whose education and work experience are acceptable to the chief inspector will be permitted to take a two (2)-part written examination. Part 1 of the examination will test the applicant's knowledge of the ASME Code. Part 2 of the examination will test the applicant's knowledge of the Missouri Boiler and Pressure Vessel Act (Act) and these rules. An applicant must pass both parts of the examination. Part 1 of the examination may be waived by the chief inspector for those applicants who have a valid national board commission.(G) Upon completing the requirements of this rule and payment of the required fees, an identification card will be issued.(H) An identification card shall be invalid when the inspector to whom it was issued is no longer employed by the organization shown on the identification card. Within thirty (30) days of termination of employment, the inspector shall return their identification card to the chief inspector. A new identification card will not be issued until the previous identification card is returned.(I) After due investigation, an identification card may be suspended for cause by the chief inspector at the recommendation of the board. Cause for suspension may include but is not limited to neglect of duty, untrustworthiness, conflict of interest, or willful falsification of information on a report of inspection or an application for an identification card. Falsification of information on a report may include, but is not limited to the omission of material information that would affect the issuance or non-issuance of an inspection certificate.(3) Inspector's Responsibilities. (A) The inspector is responsible for: 1. Performing a complete and thorough inspection of each object in accordance with the Act and these rules;2. Submitting inspection reports in accordance with the requirements of these rules and reporting any condition that is not in accordance with the Act or these rules;3. Notifying the chief inspector of a boiler, water heater, or pressure vessel failure or of an injury or fatality involving a boiler, water heater, or pressure vessel incident in a timely manner; and4. Advising owner/users of the requirements of the Act and these rules;(B) The inspector shall not receive reimbursement for operating or servicing any boiler, water heater or pressure vessel in Missouri or engaging in:1. The sale, manufacture or repair of any boiler, water heater or pressure vessel; or2. The sale of any chemical, service, article or device relating to boilers, water heaters or pressure vessels or their appurtenances. AUTHORITY: section 650.215, RSMo 2000.* Original rule filed Sept. 25, 2002, effective May 30, 2003. *Original authority: 650.215, RSMo 1984, amended 1990, 1993, 1995.