Section R. 339.6033 - Cleaning, disinfecting, and sterilizing tools and equipmentRule 33.
(1) Unless otherwise provided under this rule, a licensee, student, or apprentice shall disinfect all non-electrical tools that are not disposed of after each use on a patron in the following sequential manner: (a) Remove all visible debris.(b) Wipe sharp-edged tools with a 70% alcohol solution.(c) Disinfect using 1 of the following methods:(i) Exposing all surfaces to UV light in compliance with the requirements for disinfection established by the manufacturer of the disinfecting device.(ii) Fully immersing in a wet sanitizer that contains a sanitizing agent registered with the EPA for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.(iii) Scrubbing all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.(d) Fully dry by air or with a clean towel before storing in a clean, covered place such as a fully enclosed drawer, cabinet, or container.(2) Unless otherwise provided under this rule, a licensee, student, or apprentice shall disinfect all removeable parts of an electrical tool after each use on a patron in the following sequential manner:(a) Remove all visible debris.(b) Wipe sharp-edged tools with an alcohol solution of, at a minimum, 70% alcohol.(c) Disinfect using 1 of the following methods:(i) Exposing all surfaces to UV light in compliance with the requirements for disinfection established by the manufacturer of the disinfecting device.(ii) Fully immersing in a wet sanitizer that contains a sanitizing agent registered with the EPA for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.(iii) Scrubbing all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.(d) Fully dry by air or with a clean towel before storing in a clean, covered place such as a fully enclosed drawer, cabinet, or container. Electrical items with a cord must not be stored in a container used for storing other clean items.(3) A licensee, student, or apprentice shall disinfect a shampoo bowl after each use in the following sequential manner: (a) Remove all visible debris.(b) Scrub all surfaces with a disinfectant wipe or clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.(4) A licensee, student, or apprentice shall dispose of a single-use duster or other brush after each use or disinfect a reusable duster or other brush in the following sequential manner after each use:(a) Remove all visible debris.(b) Wash with soap or detergent and water and rinse with clean water.(c) Immerse in a wet sanitizer for not less than 10 minutes or the period recommended by the manufacturer of the disinfectant.(5) A licensee, student, or apprentice shall disinfect every barbering chair, headrest, or other station that comes in direct contact with a patron's skin after use by a patron in the following sequential manner:(a) Remove all visible debris.(b) Scrub all surfaces with a disinfectant wipe or a clean towel and disinfectant spray that contains a disinfecting agent registered with the EPA.Mich. Admin. Code R. 339.6033
1991 AACS; 2019 AACS; 2023 MR 19, Eff. 10/2/2023