Section R. 336.1205 - Permit to install; approvalRule 205.
(1) The department shall not approve a permit to install for a stationary source, process, or process equipment that meets the definition of a major stationary source or major modification under any part of these rules unless the requirements specified in subdivisions (a) and (b) of this subrule have been met. In addition, except as provided in subrule (3) of this rule, the department shall not approve a permit to install that includes limitations which restrict the potential to emit from a stationary source, process, or process equipment to a quantity below that which would constitute a major source or major modification under any part of these rules unless both of the following requirements have been met:(a) The permit to install contains emission limits that are enforceable as a practical matter. An emission limit restricts the amount of an air contaminant that may be emitted over some time period. The time period shall be set in accordance with the applicable requirements and, unless a different time period is provided by the applicable requirement, should generally not be more than 1 month, unless a longer time period is approved by the department. A longer time period may be used if it is a rolling time period, but shall not be more than an annual time period rolled on a monthly basis. If the emission limit does not reflect the maximum emissions of the process or process equipment operating at full design capacity without air pollution control equipment, then the permit shall contain 1of the following: (i) A production limit that restricts the amount of final product that may be produced over the same time period used in the emission limit and that comports with the true design and intended operation of the process or process equipment.(ii) An operational limit that restricts the way the process or process equipment is operated and that comports with the true design and intended operation of the process or process equipment. An operational limit may include conditions specifying any of the following: (A) The installation, operation, and maintenance of air pollution control equipment.(B) The hours of operation of the stationary source, process, or process equipment, if the hours are less than continuous.(C) The amount or type of raw materials used by the stationary source, process, or process equipment.(D) The amount or type of fuel combusted by the stationary source, process, or process equipment.(E) The installation, operation, and maintenance of a continuous gas flow meter and a continuous emission monitor for the air contaminant for which an enforceable emission limit is required.(iii) For volatile organic compound surface coating operations where an add-on control is not employed, an emission or usage limit coupled with a requirement to calculate or demonstrate daily compliance.(b) A draft permit has been subjected to the public participation process specified in section 5511(3) of the act. The department shall provide a copy of the draft permit to the United States environmental protection agency for review and comment at or before the start of the public comment period. The department shall also provide a copy of each final permit to install issued pursuant to this rule to the United States environmental protection agency.(2) The department shall not approve a permit to install to construct a major source or reconstruct a major source under any applicable requirement of section 112 of the clean air act unless the requirements of subrule (1)(a) and (b) of this rule have been met. In addition, except as provided in subrule (3) of this rule, the department shall not approve a permit to install that includes limitations which restrict the potential to emit of a stationary source, process, or process equipment to a quantity below that which would constitute a major source or modification under any applicable requirement of section 112 of the clean air act unless the requirements of subrule (1)(a) and (b) of this rule have been met.(3) The department may approve a permit to install that includes limitations that restrict the potential to emit of a stationary source, process, or process equipment to a quantity below that which would constitute a major source or major modification under any part of these rules without meeting the requirement of subrule (1)(b) of this rule if the emission limitations restrict the potential to emit of the stationary source, process, or process equipment to less than 90% of the quantity referenced in the applicable requirement.Mich. Admin. Code R. 336.1205
1995 AACS; 1996 AACS; 1998 AACS; 2003 AACS; 2008 AACS; 2016 MR 24, Eff. 12/20/2016