Mich. Admin. Code R. 336.2902

Current through Vol. 24-21, December 1, 2024

Section R. 336.2902 - Applicability

Rule 1902.

(1) This part applies to the construction of each new major stationary source or major modification that is both of the following:

(a) Located in a nonattainment area.

(b) Major for the pollutant for which the area is designated nonattainment.

For areas designated as nonattainment for ozone, this part shall apply only to any new major stationary source or major modification that is major for volatile organic compounds or nitrogen oxides.

(2) This part applies to the construction of new major sources and major modifications to existing major sources as follows:

(a) Except as otherwise provided in subrule (3) of this rule, and consistent with the definition of major modification, a project is a major modification for a regulated new source review pollutant if it causes both of the following emissions increases:

(i) A significant emissions increase.

(ii) A significant net emissions increase. The project is not a major modification if it does not cause a significant emissions increase. If the project causes a significant emissions increase, then the project is a major modification only if it also results in a significant net emissions increase.

(b) The procedure for calculating whether a significant emissions increase will occur depends upon the type of emissions units being modified. The procedure for calculating whether a significant net emissions increase will occur at the major stationary source is contained in the definition of net emissions increase. Regardless of any such preconstruction projections, a major modification results if the project causes a significant emissions increase and a significant net emissions increase.

(c) The actual-to-projected-actual applicability test may be used for projects that only involve existing emissions units. A significant emissions increase of a regulated new source review pollutant is projected to occur if the sum of the difference between the projected actual emissions and the baseline actual emissions, for each existing emissions unit, equals or exceeds the significant amount for that pollutant.

(d) The actual-to-potential test may be used for projects that involve construction of new emissions units or modification of existing emissions units. A significant emissions increase of a regulated new source review pollutant is projected to occur if the sum of the difference between the potential to emit from each new or modified emissions unit following completion of the project and the baseline actual emissions of these units before the project equals or exceeds the significant amount for that pollutant.

(e) The hybrid test may be used for projects that involve multiple types of emissions units. A significant emissions increase of a regulated new source review pollutant is projected to occur if the sum of the emissions increases for each emissions unit, using the appropriate methods specified above in this subrule as applicable with respect to each emissions unit, for each type of emissions unit equals or exceeds the significant amount for that pollutant.

(3) Any major stationary source for a plant wide applicability limit for a regulated new source review pollutant shall comply with R 336.2907.

(4) The provisions of this rule do not apply to a source or modification that would be a major stationary source or major modification only if fugitive emissions to the extent quantifiable are considered in calculating the potential to emit of the stationary source or modification and the source does not belong to any of the following categories:

(a) Coal cleaning plants, with thermal dryers.

(b) Kraft pulp mills.

(c) Portland cement plants.

(d) Primary zinc smelters.

(e) Iron and steel mills.

(f) Primary aluminum ore reduction plants.

(g) Primary copper smelters.

(h) Municipal incinerators capable of charging more than 250 tons of refuse per day.

(i) Hydrofluoric, sulfuric, or citric acid plants.

(j) Petroleum refineries.

(k) Lime plants.

(l) Phosphate rock processing plants.

(m) Coke oven batteries.

(n) Sulfur recovery plants.

(o) Carbon black plants, furnace process.

(p) Primary lead smelters.

(q) Fuel conversion plants.

(r) Sintering plants.

(s) Secondary metal production plants.

(t) Chemical process plants.

(u) Fossil-fuel boilers, or combination thereof, totaling more than 250 million British thermal units per hour heat input.

(v) Petroleum storage and transfer units with a total storage capacity exceeding 300,000 barrels.

(w) Taconite ore processing plants.

(x) Glass fiber processing plants.

(y) Charcoal production plants.

(z) Fossil fuel-fired steam electric plants of more than 250 million British thermal units per hour heat input.

(aa) Any other stationary source category which, as of August 7, 1980, is regulated under section 111 or 112 of the clean air act.

(5) The following additional construction and permitting requirements apply:

(a) Approval to construct shall not relieve any owner or operator of the responsibility to comply fully with any other applicable requirements and any other requirements under local, state, or federal law.

(b) At such time that a particular source or modification becomes a major stationary source or major modification solely by virtue of a relaxation in any enforcement limitation that was established after August 7, 1980, on the capacity of the source or modification otherwise to emit a pollutant, such as a restriction on hours of operation, then the requirements of R 336.2908 shall apply to the source or modification as though construction had not yet commenced on the source or modification.

(6) The following provisions apply to projects at existing emissions units at a major stationary source that is subject to either prevention of significant deterioration of air quality regulations or new source review for major sources in nonattainment areas regulations in circumstances where there is a reasonable possibility that a project that is not a part of a major modification may result in a significant emissions increase and the owner or operator elects to use the method in R 336.2901(dd) or R 336.2801(ll) for calculating projected actual emissions:

(a) Before beginning actual construction of the project, the owner or operator shall document and maintain a record of the following information:

(i) A description of the project.

(ii) Identification of the emissions units whose emissions of a regulated new source review pollutant may be affected by the project.

(iii) A description of the applicability test used to determine that the project is not a major modification for any regulated new source review pollutant, including the baseline actual emissions, the projected actual emissions, the amount of emissions excluded under R 336.2901(dd)(ii)(C) and an explanation for why such amount was excluded, and any netting calculations, if applicable.

(b) If the emissions unit is an existing electric utility steam generating unit, before beginning actual construction, the owner or operator shall provide a copy of the information required by subdivision (a) of this subrule to the department. This subdivision does not require the owner or operator of such a unit to obtain any determination from the department before beginning actual construction.

(c) The owner or operator shall monitor the emissions of any regulated new source review pollutant that could increase as a result of the project and that is emitted by any emissions units identified under subdivision (a)(ii) of this subrule and calculate and maintain a record of the annual emissions, in tons per year on a calendar year basis, for a period of 5 years following resumption of regular operations after the change, or for a period of 10 years following resumption of regular operations after the change if the project increases the design capacity or potential to emit of that regulated new source review pollutant at the emissions unit.

(d) If the unit is an existing electric utility steam generating unit, then the owner or operator shall submit a report to the department within 60 days after the end of each year during which records shall be generated under subdivision (c) of this subrule setting out the unit's annual emissions during the year that preceded submission of the report.

(e) If the unit is an existing unit other than an electric utility steam generating unit, then the owner or operator shall submit a report to the department if the annual emissions, in tons per year, from the project identified pursuant to this subrule, exceed the baseline actual emissions by a significant amount for that regulated new source review pollutant, and if such emissions differ from the preconstruction projection. The report shall be submitted to the department within 60 days after the end of such year. The report shall contain all of the following information:

(i) The name, address and telephone number of the major stationary source.

(ii) The annual emissions as calculated under subdivision (c) of this subrule.

(iii) Any other information that the owner or operator wishes to include in the report, for example, an explanation as to why the emissions differ from the preconstruction projection.

(f) A reasonable possibility that a project may result in a significant emissions increase occurs when the project is subject to R 336.1201(1)(a) and is not exempted from the requirement to obtain a permit to install by R 336.1278 to R 336.1290. If the owner or operator determines that the project is exempted by R 336.1278 to R 336.1290, then the owner or operator may proceed with the project without obtaining a permit to install. If an owner or operator develops calculations for the project pursuant to R 336.2901(dd) or R 336.2801(ll), the calculations may be used for the purpose of demonstrating compliance with R 336.1278a(1)(c).

(7) The owner or operator of the source shall make the information required to be documented and maintained under this rule available for review upon a request for inspection by the department, or the general public under section 5516(2) of the act, MCL 324.5516(2).

(8) The requirements of this part that apply to major stationary sources and major modifications of volatile organic compounds shall also apply to nitrogen oxides emissions from major stationary sources and major modifications of nitrogen oxides in an ozone transport region or in any ozone nonattainment area, except in ozone nonattainment areas or portions of an ozone transport region where the United States environmental protection agency has granted a NOx waiver applying the standards set forth under section 182(f) of the clean air act and the waiver continues to apply.

Mich. Admin. Code R. 336.2902

2008 AACS; 2019 MR 1, Eff. 1/2/2019