Md. Code Regs. 26.10.08.01

Current through Register Vol. 51, No. 22, November 1, 2024

Section 26.10.08.01 - Reporting of Suspected Spills, Releases, and Discharges

A. An owner and an operator of a storage tank system, a responsible party, and a person conducting a test on a storage tank system shall report to the Department a suspected spill, release, or discharge immediately, but not later than 2 hours after the discovery, and follow the investigation and confirmation procedures in Regulation .03 of this chapter if any of the following circumstances occur:

(1) There is evidence of a spill, release, or discharge of oil;

(2) There is evidence of a spill, release, or discharge of a regulated substance from a UST system;

(3) A storage tank system fails a precision tightness test;

(4) A storage tank system has two consecutive inconclusive precision tightness test results;

(5) A storage tank system is determined to have a leak or there is evidence of a spill, release, or discharge of oil at an oil storage facility or oil handling facility, such as the presence of:

(a) Dissolved product in groundwater;

(b) Absorbed product in soils;

(c) Free product in soils, a basement, a sewer or utility line, or waters of the State; or

(d) Vapors in soils, a basement, a sewer or utility line, or waters of the State;

(6) There is evidence of a spill, release, or discharge at a regulated substance storage facility or in the surrounding area, such as the presence of:

(a) Dissolved product in groundwater;

(b) Absorbed product in soils;

(c) Free product in soils, a basement, a sewer or utility line, or waters of the State; or

(d) Vapors in soils, a basement, a sewer or utility line, or waters of the State;

(7) Unusual operating conditions exist, such as:

(a) The erratic behavior of product-dispensing equipment;

(b) The sudden loss of a regulated substance from a storage tank system;

(c) An unexplained presence of water in a storage tank;

(d) Liquid in the interstice space of secondarily contained systems; or

(e) A failed spill prevention equipment or containment sump test for tightness; and

(8) Monitoring results, including investigation of an alarm, from a release detection method required under COMAR 26.10.05 indicate a spill, release, or discharge may have occurred, unless:

(a) The monitoring device is found to be defective and immediately repaired, recalibrated or replaced; and

(b) Additional monitoring does not confirm the initial result.

B. Additional Reporting Circumstances.

(1) For the purposes of this section, evidence of a spill, release, or discharge include:

(a) The visual detection of free product; or

(b) An analytical laboratory report that shows a detection of a petroleum constituent in a soil, groundwater, drinking water, or soil vapor sample at a concentration equal to or exceeding a cleanup standard or action level published by the Department for the petroleum constituent and media type.

(2) If evidence of a spill, release, or discharge is discovered during an environmental assessment conducted on a property as part of a due diligence investigation in support of a property transaction or a loan refinancing, the person conducting the environmental assessment and the owner of the property shall report the suspected spill, release, or discharge to the Department:

(a) Immediately, but not later than 2 hours after the visual detection of free product; or

(b) Within 48 hours of receiving an analytical laboratory report described under §B(1) of this regulation.

(3) The person performing an environmental assessment on a property or the owner of the property may not be considered a person responsible for the discharge solely as a result of discovering evidence of a spill, release, or discharge or reporting a suspected spill, release, or discharge to the Department in compliance with §B(1) of this regulation, unless the person performing the environmental assessment or the property owner meets the criteria for a person responsible for the discharge under COMAR 26.10.01.02B.

Md. Code Regs. 26.10.08.01

Regulation .01 adopted effective 49:12 Md. R. 642, eff. 6/13/2022