Md. Code Regs. 11.04.06.02

Current through Register Vol. 51, No. 24, December 2, 2024

Section 11.04.06.02 - Standards and Specifications

A. All work and materials shall conform to Administration construction specifications, standards, and addenda current at the time of the permit grant.

B. All work is subject to periodic inspection and final approval by the Administration.

C. The number and location of entrances which may be granted shall be based on usage, interior and exterior traffic patterns, and current design policy of the Administration.

D. Circular drives (ingress and egress point connected by a common driveway) require a minimum frontage of 100 feet.

E. The minimum width of a residential entrance is 10 feet, and the maximum width is 20 feet, unless otherwise permitted by the district engineer. Any exception shall be made by a permit, signed by the district engineer.

F. Existing sidewalks, curb, and gutter disturbed by construction shall be replaced in kind to the alignment and grade specified by authorized Administration personnel in a manner acceptable to the Administration.

G. Positive drainage shall be maintained. Minimum pipe size is 18 inches or equivalent elliptical pipe. An end section or end walls, required by the resident maintenance engineer, shall be installed at the ends of the pipe. All pipes shall be State-approved or certified. Drainage pipes shall be located as far as practicable from the edge of a travelled lane to reduce the hazard to traffic. The minimum desirable distance is 30 feet. When pipe headwalls for other physical obstructions are placed within the clear zone, they shall be protected by guardrails or other appropriate barrier system.

H. Paving.

(1) Area with Existing Sidewalks and Concrete Curb and Gutter. Paving shall consist of 6 inches Portland cement concrete on a suitable subbase.

(2) Area Without Sidewalks and Concrete Curb and Gutter. Paving shall consist of 3-1/2 inches bituminous concrete (2 inch base, 1-1/2 inch surface) on 6 inches crusher run stone or 6 inches selected backfill. Variance to suit the conditions and locale may be made by a permit, signed by the district engineer.

I. If the roadway is on an embankment and the roadway is not provided with existing standard traffic barriers along the roadway embankment, the driveway or embankment side slope shall be as flat as possible to reduce the hazard to traffic. The minimum desirable embankment side slope shall be 10:1 within 30 feet of the edge of the travelled lane or to the right-of-way line, whichever is less.

J. Mailboxes.

(1) Mailboxes erected within the State Highway Administration's right-of-way shall be placed on a break-away type post or support.

(2) The maximum size wooden post shall be 4 x 4 inches. The maximum size pipe type support shall be 2 inches in diameter. Any other type of support, ornamental or otherwise, may not have a structural strength greater than either of the two items listed above.

(3) The property owner shall be directed to remove any mailbox support of a size greater than that listed above, and if not removed by the property owner, it shall be removed by the State Highway Administration's forces.

Md. Code Regs. 11.04.06.02

Regulation .02 amended effective September 3, 1990 (17:17 Md. R. 2082)
Regulation .02F amended effective January 14, 2010 (37:1 Md. R. 15)