Section 096-523-9 - Disposal of pollutants into wells, into publicly owned treatment works or by land application [see 40 CFR 122.50](a) When part of a discharger's process wastewater is not being discharged into waters of the State or contiguous zone because it is disposed into a well, into a POTW, or by land application thereby reducing the flow or level of pollutants being discharged into waters of the State, applicable effluent standards and limitations for the discharge in an NPDES permit shall be adjusted to reflect the reduce draw waste resulting from such disposal. Effluent limitations and standards in the permit shall be calculated by one of the following methods: (1) If none of the waste from a particular process is discharged into waters of the State, and effluent limitations guidelines provide separate allocation for wastes from that process, all allocations for the process shall be eliminated from calculation of permit effluent limitations or standards.(2) In all cases other than those described in paragraph (a)(1) of this section, effluent limitations shall be adjusted by multiplying the effluent limitation derived by applying effluent limitation guidelines to the total waste stream by the amount of wastewater flow to be treated and discharged into waters of the State, and dividing the result by the total wastewater flow. Effluent limitations and standards so calculated may be further adjusted under Chapter 524 to make them more or less stringent if discharges to wells, publicly owned treatment works, or by land application change the character or treatability of the pollutants being discharged to receiving waters. This method may be algebraically expressed as: P = (E x N) / T
where P is the permit effluent limitation, E is the limitation derived by applying effluent guidelines to the total waste stream, N is the wastewater flow to be treated and discharged to waters of the State, and T is the total wastewater flow.
(b) Paragraph (a) of this section does not apply to the extent that promulgated effluent limitations guidelines: (1) Control concentrations of pollutants discharged but not mass; or(2) Specify a different specific technique for adjusting effluent limitations to account for well injection, land application, or disposal into POTWs.(c) Paragraph (a) of this section does not alter a discharger's obligation to meet any more stringent requirements established under Sections 2, 3, 4, and 5. 06- 096 C.M.R. ch. 523, § 9