Current through Register Vol. 50, No. 11, November 20, 2024
Section XVII-3337 - Closure and Post-ClosureA. Closure. The owner or operator shall close the solution-mining well, cavern, surface facility or parts thereof as approved by the Office of Conservation. Closure shall not begin without written authorization from the Office of Conservation. 1. Notice of Intent to Close a. The operator shall review the closure plan before seeking authorization to begin closure activities to determine if the conditions for closure are still relevant to the actual conditions of the solution-mining well, cavern, or surface facility. Revisions to the method of closure reflected in the plan shall be submitted to the Office of Conservation for approval no later than the date on which the notice of closure is required to be submitted as shown in the subparagraph below.b. The operator shall notify the Office of Conservation in writing at least 30 days before the expected closure of a solution-mining well, cavern, or surface facility. Notification shall be by submission of a request for a work permit. At the discretion of the Office of Conservation, a shorter notice period may be allowed.2. Closure Plan. Plans for closure of the solution mining well, cavern, and related surface facility shall be submitted as part of the permit application. The closure plan shall meet the requirements of these rules and regulations and be acceptable to the Office of Conservation. The obligation to implement the closure plan survives the termination of a permit or the cessation of mining operations or related activities. The requirement to maintain and implement an approved plan is directly enforceable regardless of whether the requirement is a condition of the permit. The Office of Conservation may modify a closure plan where necessary.3. Closure Plan Requirements. The owner or operator shall review the closure plan annually to determine if the conditions for closure are still applicable to the actual conditions of the solution-mining well, cavern, or surface facility. Any revision to the plan shall be submitted to the Office of Conservation for approval. At a minimum, a closure plan shall address the following:a. assurance of financial responsibility as required in §3309.B.1 All instruments of financial responsibility shall be reviewed each year before its renewal date according to the following process: i. a detailed cost estimate for adequate closure (plugging and abandonment) of the well and related appurtenances entire solution-mining well facility (solution mining well, cavern, surface appurtenances, etc.) shall be prepared by a qualified professional. The closure plan and cost estimate shall include provisions for closure acceptable and submitted to the Office of Conservation by the date specified in the permit;ii. the closure plan and cost estimate shall include provisions for closure acceptable to the Office of Conservation;iii. after reviewing the required closure cost estimate, the Office of Conservation may amend the required financial surety to reflect the estimated costs to the Office of Conservation to complete the approved closure of the facility increase, decrease or allow the amount to remain the same;iv. documentation from the operator showing that the required financial instrument has been renewed shall be received each year by the date specified in the permit. When an operator is delinquent in submitting documentation of financial instrument renewal, the Office of Conservation shall initiate procedures to take possession of funds guaranteed by the financial instrument and suspend or revoke the operating permit. Permit suspensions shall remain in effect until renewal documentation is received and accepted by the Office of Conservation;b. a prediction of the pressure build-up in the cavern following closure;c. an analysis of potential pathways for leakage from the cavern, cemented casing shoe, and wellbore. Consideration shall be given to site specific elements of geology, salt cavern geometry and depth, cavern pressure build-up over time due to salt creep and other factors inherent to the salt stock and/or salt dome;d. procedures for determining the mechanical integrity of the solution-mining well and cavern before closure;e. removal and proper disposal of any waste or other materials remaining at the facility;f. closing, dismantling, and removing all equipment and structures located at the surface (including site restoration) if such equipment and structures will not be used for another purpose at the same solution-mining facility;g. the type, number, and placement of each wellbore or cavern plug including the elevation of the top and bottom of each plug;h. the type, grade, and quantity of material to be used in plugging;i. a description of the amount, size, and location (by depth) of casing and any other well construction materials to be left in the solution-mining well;j. any proposed test or measurement to be made before or during closure.4. Standards for Closure. The following are minimum standards for closing the solution-mining well or cavern. The Office of Conservation may require additional standards prior to actual closure. a. After permanently concluding mining operations into the cavern but before closing the solution-mining well or cavern, the owner or operator shall:i. observe and accurately record the shut-in salt cavern pressures and cavern fluid volume for no less than five years or a time period specified by the Office of Conservation to provide information regarding the cavern's natural closure characteristics and any resulting pressure buildup;ii. using actual pre-closure monitoring data, show and provide predictions that closing the solution-mining well or cavern as described in the closure plan will not result in any pressure buildup within the cavern that could adversely affect the integrity of the solution-mining well, cavern, or any seal of the system.b. Unless the well is being plugged and abandoned due to a failed mechanical integrity test and the condition of the casing and cavern are known, before closure, the owner or operator shall do mechanical integrity pressure and leak tests to ensure the integrity of both the solution-mining well and cavern.c. Before closure, the owner or operator shall remove and properly dispose of any free oil or blanket material remaining in the solution-mining well or cavern.d. Upon permanent closure, the owner or operator shall plug the solution-mining well with cement in a way that will not allow the movement of fluids into or between underground sources of drinking water or outside the salt stock.5. Plugging and Abandonment. The well/cavern to be abandoned shall be in a state of static equilibrium prior to plugging. a. A continuous column of cement shall fill the deepest cemented casing from shoe to surface via a series of cement plugs and shall be accomplished as follows:i. a balanced cement plug shall be placed across the shoe of the deepest cemented casing, tagged to verify the top of cement, and pressure tested to at least 300 PSI for 30 minutes before setting the next cement plug; andii. subsequent cement plugs shall be spotted immediately on top of the previously-placed cement plug. Each plug shall be tagged to verify the top of cement before the next plug is placed.b. After placing the top plug, the operator shall be required on all land locations to cut and pull the casings a minimum of 5 feet below ground level. A 1/2 inch thick steel plate shall be welded across the top of all casings. The plate shall be inscribed with the plug and abandonment date and the well serial number on top. On all water locations, the casings shall be cut and pulled a minimum of 15 feet below the mud line.c. The plan of abandonment may be altered if new or unforeseen conditions arise during the well work, but only after approval by the Office of Conservation.6. Closure Report. The owner or operator shall submit a closure report to the Office of Conservation within 60 days after closure of the solution-mining well, cavern, surface facility, or part thereof. The report shall be submitted electronically and shall be certified as accurate by the owner or operator and by the person charged with overseeing the closure operation (if other than the owner or operator). The report shall contain the following information: a. detailed procedures of the closure operation. Where actual closure differed from the plan previously approved, the report shall include a written statement specifying the differences between the previous plan and the actual closure;b. the appropriate Office of Conservation plug and abandon report form (Form UIC-P&A or successor); andc. any information pertinent to the closure activity including test or monitoring data.B. Post-Closure. Plans for post-closure care of the solution-mining well, cavern, and related surface facility shall be submitted as part of the permit application. The post-closure plan shall meet the requirements of these rules and regulations and be acceptable to the Office of Conservation. The obligation to implement the post-closure plan survives the termination of a permit or the cessation of mining operations or related activities. The requirement to maintain and implement an approved post-closure plan is directly enforceable regardless of whether the requirement is a condition of the permit. The Office of Conservation may modify a post-closure plan where necessary. 1. The owner or operator shall review the post-closure plan at least every five years to determine if the conditions for post-closure are still applicable to actual conditions. Any revision to the plan shall be submitted to the Office of Conservation for approval. At a minimum, a post-closure plan shall address the following: a. assurance of financial responsibility as required in §3309. B.1 All instruments of financial responsibility shall be reviewed each year before its renewal date according to the following process: i. a detailed cost estimate for adequate post-closure care of the entire solution-mining well shall be prepared by a qualified, independent third party and submitted to the Office of Conservation by the date specified in the permit;ii. the post-closure care plan and cost estimate shall include provisions acceptable to the Office of Conservation and shall reflect the costs for the Office of Conservation to complete the approved post-closure care of the facility;iii. after reviewing the closure cost estimate, the Office of Conservation may amend the amount to reflect the costs to the Office of Conservation to complete the approved closure of the facility; iv. documentation from the operator showing that the required financial instrument has been renewed must be received each year by the date specified in the permit. When an operator is delinquent in submitting documentation of financial instrument renewal, the Office of Conservation shall initiate procedures to take possession of the funds guaranteed by the financial instrument and suspend or revoke the operating permit. Any permit suspension shall remain in effect until renewal documentation is received and accepted by the Office of Conservation.b. any plans for monitoring, corrective action, site remediation, site restoration, etc., as may be necessary.2. Where necessary and as an ongoing part of post-closure care, the owner or operator shall continue the following activities: a. conduct subsidence monitoring for a period of no less than 10 years after closure of the facility;b. complete any corrective action or site remediation resulting from the operation of a solution-mining well;c. conduct any groundwater monitoring by the permit or approved corrective action plan;d. complete any site restoration.3. The owner or operator shall retain all records as required in §3335 for five years following conclusion of post-closure requirements.La. Admin. Code tit. 43, § XVII-3337
Promulgated by the Department of Natural Resources, Office of Conservation, LR 40:340 (February 2014), Amended LR 482315 (9/1/2022).AUTHORITY NOTE: Promulgated in accordance with R.S. 30:4 et seq.