La. Admin. Code tit. 43 § XIII-1713

Current through Register Vol. 50, No. 11, November 20, 2024

Section XIII-1713 - Bends and Elbows [49 CFR 192.313]

A. Each field bend in steel pipe, other than a wrinkle bend made in accordance with §1715, must comply with the following. [ 49 CFR 192.313(a)]

1. A bend must not impair the serviceability of the pipe. [ 49 CFR 192.313(a)(1)]

2. Each bend must have a smooth contour and be free from buckling, cracks, or any other mechanical damage. [ 49 CFR 192.313(a)(2)]

3. On pipe containing a longitudinal weld, the longitudinal weld must be as near as practicable to the neutral axis of the bend unless: [ 49 CFR 192.313(a)(3)]

a. the bend is made with an internal bending mandrel; or [ 49 CFR 192.313(a)(3)(i)]

b. the pipe is 12 inches (305 millimeters) or less in outside diameter or has a diameter to wall thickness ratio less than 70. [49 CFR 192.313(a)(3)(ii)]

B. Each circumferential weld of steel pipe which is located where the stress during bending causes a permanent deformation in the pipe must be nondestructively tested either before or after the bending process. [ 49 CFR 192.313(b)]

C. Wrought-steel welding elbows and transverse segments of these elbows may not be used for changes in direction on steel pipe that is 2 inches (51 millimeters) or more in diameter unless the arc length, as measured along the crotch, is at least 1 inch (25 millimeters). [ 49 CFR 192.313(c)]

D. An operator may not install plastic pipe with a bend radius that is less than the minimum bend radius specified by the manufacturer for the diameter of the pipe being installed. [49 CFR 192.313(d)]

La. Admin. Code tit. 43, § XIII-1713

Promulgated by the Department of Natural Resources, Office of Conservation, LR 9:232 (April 1983), amended LR 10:524 (July 1984), LR 27:1542 (September 2001), LR 30:1246 (June 2004), Amended LR 461586 (11/1/2020).

AUTHORITY NOTE: Promulgated in accordance with R.S. 30:501 et seq.