Statutes, codes, and regulations
Louisiana Administrative Code
Title 33 - ENVIRONMENTAL QUALITYPart V - Hazardous Waste and Hazardous MaterialsSubpart 3 - Natural ResourcesChapter 301 - Transportation of Hazardous Liquids by Pipeline [49 CFR Part 195]
Subchapter A - General [49 CFR Part 195 Subpart A]
Section V-30117 - What is a regulated rural gathering line and what requirements apply? [49 CFR 195.11]

La. Admin. Code tit. 33 § V-30117

Download
PDF
Current through Register Vol. 50, No. 11, November 20, 2024
Section V-30117 - What is a regulated rural gathering line and what requirements apply? [49 CFR 195.11]
A. Each operator of a regulated rural gathering line, as defined in Paragraph 1 of this section, must comply with the safety requirements described in Paragraph 2 of this Section. [49 CFR 195.11]
1. Definition. As used in this section, a regulated rural gathering line means an onshore gathering line in a rural area that meets all of the following criteria- [49 CFR 195.11(a)]
a. has a nominal diameter from 65/8 inches (168 mm) to 85/8 inches (219.1 mm); [49 CFR 195.11(a)(1)]
b. is located in or within one-quarter mile (.40 km) of an unusually sensitive area as defined in §30112; and [49 CFR 195.11(a)(2)]
c. operates at a maximum pressure established under §30406 corresponding to: [49 CFR 195.11(a)(3)]
i. A stress level greater than 20 percent of the specified minimum yield strength of the line pipe; or [49 CFR 195.11(a)(3)(i)]
ii. if the stress level is unknown or the pipeline is not constructed with steel pipe, a pressure of more than 125 psi (861 kPa) gage. [49 CFR 195.11(a)(3)(ii)]
2. Safety Requirements. Each operator must prepare, follow, and maintain written procedures to carry out the requirements of this section. Except for the requirements in Subparagraphs A.2.b, A.2.c, A.2.i and A.2.j of this section, the safety requirements apply to all materials of construction. [49 CFR 195.11(b)]
a. Identify all segments of pipeline meeting the criteria in Paragraph 1 of this section before April 3, 2009. [49 CFR 195.11(b)(1)]
b. For steel pipelines constructed, replaced, relocated, or otherwise changed after July 3, 2009:, [49 CFR 195.11(b)(2)]
i. Design, install, construct, initially inspect, and initially test the pipeline in compliance with this part, unless the pipeline is converted under §30111 [49 CFR 195.11(b)(2)(i)]
ii. Reserved [49 CFR 195.11(b)(2)(ii)]
c. For non-steel pipelines constructed after July 3, 2009, notify the Administrator according to §30114 [49 CFR 195.11(b)(3)]
d. Beginning no later than January 3, 2009, comply with the reporting requirements in Subchapter B of Chapter 301 this Subpart. [49 CFR 195.11(b)(4)]
e. Establish the maximum operating pressure of the pipeline according to §30406 before transportation begins, or if the pipeline exists on July 3, 2008, before July 3, 2009. [49 CFR 195.11(b)(5)]
f. Install line markers according to §30410 before transportation begins, or if the pipeline exists on July 3, 2008, before July 3, 2009. Continue to maintain line markers in compliance with §30410 [49 CFR 195.11(b)(6)]
g. Establish a continuing public education program in compliance with §30440 before transportation begins, or if the pipeline exists on July 3, 2008, before January 3, 2010. Continue to carry out such program in compliance with §30440 [49 CFR 195.11(b)(7)]
h. Establish a damage prevention program in compliance with §30442 before transportation begins, or if the pipeline exists on July 3, 2008, before July 3, 2009. Continue to carry out such program in compliance with §30442 [49 CFR 195.11(b)(8)]
i. For steel pipelines, comply with Subchapter B of Chapter 305 of this Subpart, except corrosion control is not required for pipelines existing on July 3, 2008 before July 3, 2011. [49 CFR 195.11(b)(9)]
j. For steel pipelines, establish and follow a comprehensive and effective program to continuously identify operating conditions that could contribute to internal corrosion. The program must include measures to prevent and mitigate internal corrosion, such as cleaning the pipeline and using inhibitors. This program must be established before transportation begins or if the pipeline exists on July 3, 2008, before July 3, 2009. [49 CFR 195.11(b)(10)]
k. To comply with the Operator Qualification program requirements in Subchapter A of Chapter 305 of this Subpart, have a written description of the processes used to carry out the requirements in §30505 to determine the qualification of persons performing operations and maintenance tasks. These processes must be established before transportation begins or if the pipeline exists on July 3, 2008, before July 3, 2009. [49 CFR 195.11(b)(11)]
3. New Unusually Sensitive Areas. If, after July 3, 2008, a new unusually sensitive area is identified and a segment of pipeline becomes regulated as a result, except for the requirements of Subparagraphs A.2.i and A.2.j of this section, the operator must implement the requirements in Subparagraphs A.2.b through A.2.k of this section for the affected segment within 6 months of identification. For steel pipelines, comply with the deadlines in Subparagraph A.2.i and A.2.j. [49 CFR 195.11(c)]
4. Record Retention. An operator must maintain records demonstrating compliance with each requirement according to the following schedule. [49 CFR 195.11(d)]
a. An operator must maintain the segment identification records required in Subparagraph A.2.a of this section and the records required to comply with A.2.j of this section, for the life of the pipe. [49 CFR 195.11(d)(1)]
b. An operator must maintain the records necessary to demonstrate compliance with each requirement in Subparagraphs A.2.b through A.2.i, and A.2.k of this section according to the record retention requirements of the referenced section or Chapter. [49 CFR 195.11(d)(2)]

La. Admin. Code tit. 33, § V-30117

Promulgated by the Department of Natural Resources, Office of Conservation, Pipeline Division, LR 35:2793 (December 2009), Amended LR 491090 (6/1/2023), Amended LR 501244 (9/1/2024).
AUTHORITY NOTE: Promulgated in accordance with R.S. 30:753.