Kan. Admin. Regs. § 5-40-15

Current through Register Vol. 43, No. 40, October 3, 2024

Section 5-40-15 - Testing a principal spillway pipe installation in a dam; general procedures

The following general procedures shall apply to all static pressure tests required by K.A.R. 5-40-14:

(a) The applicant shall conduct the test before backfilling around and over the principal spillway pipe and after laying the pipe on the grade line and connecting the pipe according to the approved plans and the manufacturer's requirements.

(b) The applicant, the applicant's representative, or the contracting officer shall make arrangements for the chief engineer, or a person designated by the chief engineer, to be present during the test.

(c) The applicant shall place a watertight plug in the downstream end of the pipe. The plug shall be sufficient to withstand a pressure of three pounds per square inch for the duration of the test. The plug shall be equipped with an acceptable means of draining the water out of the pipe after completion of the test.

(d) The applicant shall fill the pipe with water up to an elevation of 10 feet above the flow line at the pipe outlet, or up to the principal spillway inlet elevation, whichever is less, unless a different elevation is required by the test method described in K.A.R. 5-40-16(b).

(e) The applicant shall note the exact elevation of the water surface at the time the test begins.

At the end of the prescribed test duration, the applicant shall measure the water surface elevation.

(f) The applicant shall use one of the test methods described in K.A.R. 5-40-16 to determine whether the water leakage rate is acceptable.

(g) If the leakage rate determined by either of the methods described in K.A.R. 5-40-16 is not acceptable, the applicant shall determine the source of the leakage and correct the leakage. After correction, the applicant shall perform another test in accordance with K.A.R. 5-40-15 and K.A.R. 5-40-16.

(h) If the leakage rate determined by either of the methods described in K.A.R. 5-40-16 is acceptable, the applicant shall drain and backfill the pipe in the manner prescribed by the approved plans and specifications.

Kan. Admin. Regs. § 5-40-15

Authorized by K.S.A. 82a-303a; implementing K.S.A. 82a-303b; effective Sept. 22, 2000.