Kan. Admin. Regs. § 28-31-124b

Current through Register Vol. 43, No. 49, December 5, 2024

Section 28-31-124b - Procedures for permitting; modification, revocation and reissuance, or termination of permits

Each reference in this regulation to a federal regulation shall mean that federal regulation as adopted by reference in K.A.R. 28-31-124 through 28-31-279.

(a) Reasons for modification, revocation and reissuance, or termination of a permit. A permit may be modified, revoked and reissued, or terminated by the secretary only for the reasons specified in 40 CFR 270.41, 40 CFR 270.43, and K.S.A. 65-3439 and amendments thereto.

(b) Request for modification, revocation and reissuance, or termination of a permit. Any person, including the permittee or the secretary, may request that a permit be modified, revoked and reissued, or terminated. Each request shall be submitted to the department in writing and shall contain the facts and reasons supporting the request.

(c) Procedures for modification or for revocation and reissuance of a permit. Modification of a permit, and revocation and reissuance of a permit, shall be subject to the following requirements:

(1) A draft permit shall be prepared by the department if either of the following occurs:

(A) The secretary tentatively decides to modify or to revoke and reissue a permit according to the criteria specified in 40 CFR 270.41, other than 40 CFR 270.41(b)(3).

(B) The permittee requests a modification in accordance with 40 CFR 270.42(c).

(2) The draft permit shall be prepared by the department according to the following criteria:

(A) The draft permit shall incorporate the proposed changes.

(B) Additional information from the permittee may be requested by the secretary.

(C) If a permit is modified, the permittee may be required by the secretary to submit an updated application.

(D) If a permit is revoked and reissued for a cause not listed in 40 CFR 270.41(b)(3), the permittee shall submit a new application to the department.

(E) If a permit is revoked and reissued in accordance with 40 CFR 270.41(b)(3), the requirements in 40 CFR part 124, subpart G for standardized permits shall be met by the secretary and the permittee.

(3) If a permit is modified, only those conditions to be modified shall be reopened by the department when a new draft permit is prepared. All other aspects of the existing permit shall remain in effect for the duration of the unmodified permit.

(4) If a permit is revoked and reissued, the entire permit shall be reopened by the department as if the permit had expired and was being reissued. During the revocation and reissuance proceedings, the permittee shall comply with all conditions of the existing permit until a new final permit is reissued.

(5) "Class 1 modifications" and "Class 2 modifications," as defined in 40 CFR 270.42(a) and (b), shall not be subject to the requirements of this regulation.

(d) Termination of permit. If the secretary tentatively decides to terminate a permit in accordance with 40 CFR 270.43 and the permittee objects, a notice of intent to terminate shall be issued by the secretary. Each notice of intent to terminate shall be deemed a type of draft permit and shall be subject to the procedures specified in K.A.R. 28-31-124c and in K.S.A. 65-3440 and amendments thereto.

Kan. Admin. Regs. § 28-31-124b

Authorized by K.S.A. 65-3431; implementing K.S.A. 65-3431, 65-3437, and 65-3439; effective April 29, 2011.