326 Ind. Admin. Code 8-22-7

Current through December 4, 2024
Section 326 IAC 8-22-7 - Compliance procedures and test methods

Authority: IC 13-14-8; IC 13-17-3-4; IC 13-17-3-11

Affected: IC 13-15; IC 13-17

Sec. 7.

(a) Except as provided in subsections (c) and (d), the VOC and solids content of adhesives or adhesive primers shall be determined in accordance with the following:
(1) 40 CFR 60, Appendix A, Method 24*.
(2) Analytical data derived from a material safety data sheet (MSDS) or equivalent information from the supplier as long as it is based on 40 CFR 60, Appendix A, Method 24*.
(b) The organic content of exempt organic compounds shall be determined using ASTM D4457-85*, ASTM International, 100 Barr Harbor Drive, West Conshohocken, Pennsylvania 19428, as applicable.
(c) The VOC content for reactive adhesives shall be determined using the procedures for reactive adhesives in 40 CFR 63, Subpart PPPP, Appendix A*.
(d) If air pollution control equipment is used to meet the requirements of this rule, the owner or operator shall make the following determinations:
(1) The measurement of capture efficiency shall be conducted and reported in accordance with 326 IAC 8-1-4(c).
(2) The control efficiency shall be determined in accordance with 326 IAC 8-1-4(d) through 326 IAC 8-1-4(f).
(e) Grams of VOC per liter of adhesive, less water and exempt compounds, shall be calculated according to the following equation:

Click here to view

Where: Ws = weight of volatile compounds, in grams

Ww = weight of water, in grams

We = weight of exempt compounds, in grams

Vm = volume of material, in liters

Vw = volume of water, in liters

Ve = volume of exempt compounds, in liters

(f) Grams of VOC per liter of material shall be calculated according to the following equation:

Click here to view

Where: Ws = weight of volatile compounds, in grams

Ww = weight of water, in grams

We = weight of exempt compounds, in grams

Vm = volume of material, in liters

(g) Percent VOC by weight shall be calculated according to the following equation:

% VOC by weight = (Wv / W) × 100

Where: Wv = weight of VOCs in grams

W = weight of material in grams

*These documents are incorporated by reference. Copies may be obtained from the Government Printing Office, 732 North Capitol Street NW, Washington, D.C. 20401 or are available for review and copying at the Indiana Department of Environmental Management, Office of Air Quality, Indiana Government Center North, Tenth Floor, 100 North Senate Avenue, Indianapolis, Indiana 46204.

326 IAC 8-22-7

Air Pollution Control Board; 326 IAC 8-22-7; filed Nov 3, 2009, 3:31 p.m.: 20091202-IR-326090221FRA; errata filed Nov 18, 2009, 3:42 p.m.: 20091216-IR-326090221ACA